주요 콘텐츠로 건너뛰기

MacBook Air 13" Mid 2011 배터리 교체하기

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 10개에 영향을 미칩니다.

3 단계 번역중

3 단계
MacBook Air 13" Mid 2011 Battery Replacement: 0 단계, 이미지 1개 중 1개
  • When handling the battery, avoid squeezing or touching the four exposed lithium polymer cells.

  • Lift the battery from its edge nearest the logic board and remove it from the upper case.

  • When installing the new battery, if there is a thin plastic film on your replacement battery, do not attempt to remove it. It is glued on and protects the battery pack while it is inside the MacBook.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Then, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.

배터리를 취급할 때는 노출된 리튬 폴리머 셀 네 개를 누르거나 만지지 마세요.

로직 보드에 가장 가까운 가장자리에서 배터리를 들어 올려 상단 케이스에서 분리하세요

새 배터리를 설치할 때 교체용 배터리에 얇은 플라스틱 필름이 붙어 있으면 이 필름을 분리하지 마세요. 이 접착되어 있는 필름은 배터리 팩이 MacBook 내부에 있는 동안 배터리 팩을 보호합니다.

새 배터리를 설치한다면 설치 후 보정해야 합니다:

100%까지 충전한 다음 최소 2시간 이상 계속 충전하세요. 그런 다음 플러그를 뽑고 정상적으로 사용하여 배터리를 방전시키세요. 배터리 부족 경고가 표시되면 작업을 저장하고 배터리 부족으로 인해 노트북이 절전 모드로 전환될 때까지 노트북을 계속 켜두세요. 최소 5시간 이상 기다린 다음 중단 없이 노트북을 100%까지 충전하세요.

새 배터리를 설치한 후 비정상적인 작동이나 문제가 발견되면 밑줄 친 텍스트 MacBook의 SMC를 재설정해야 할 수 있습니다.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.