물건을 수리하세요 커뮤니티 상점

MacBook Air 13" 2011 中期 电池更换

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 10개에 영향을 미칩니다.

안내서로 돌아가기
영어
중국어
이전 단계

3 단계 번역중

3 단계
MacBook Air 13" Mid 2011 Battery Replacement: 0 단계, 이미지 1개 중 1개

  • When handling the battery, avoid squeezing or touching the four exposed lithium polymer cells.

  • Lift the battery from its edge nearest the logic board and remove it from the upper case.

  • When installing the new battery, if there is a thin plastic film on your replacement battery, do not attempt to remove it. It is glued on and protects the battery pack while it is inside the MacBook.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Then, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.

处理电池时，请避免挤压或接触四个暴露的锂电池。

从最靠近主板的边缘处提起电池，并将其从上壳中取出。

安装新电池时，如果更换电池上有塑料薄膜，请勿尝试将其取下。当它在MacBook内部时，它将电池组粘贴在底壳上并保护电池组。

在你使用的电池之前先 校准 它：

充电至100％，然后继续充电至少2小时。然后，拔下充电器并正常使用至电池电量完全耗尽。当您看到低电量警告时，请保存你正在做的一切事，并保持电脑一直打开，直到因电池电量不足而进入睡眠状态，之后请等待至少5个小时，然后不间断地再次将笔记本电脑充电至100％。

在你安装好你的新电池之后，如果你注意到任何不寻常问题，你可能需要重置Mac的SMC。

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.