Broke a few things on the logic board, how serious is it?

Question

iPhone 5

2012년 9월 12일에 발표된 여섯 번째 Apple iPhone입니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 검정색 또는 흰색으로 제공하였습니다.

2522 질문 전체 보기

Jordanb @jordanb64096

평판: 21

1

게시일: 2013년 12월 6일

옵션

Broke a few things on the logic board, how serious is it?

I was replacing the back housing on my iPhone 5 and when I was prying the pesky battery out I broke a few components off of the logic board. I believe they were resistors(?). My phone seems to function completely normal. What damage have I caused and will this lead to complications later on?

Here are a few images that show what came off.

First image shows where one of the black squares broke off like those farther up to the right

http://i.imgur.com/oDLiwjS.jpg

second image is one of the tiny components that broke off that look like the ones around it

http://i.imgur.com/ZCH35IF.jpg

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 -1

댓글 달기

답변 1개

선택된 답변

Tom Chai @tomchai

평판: 73.8k

19

111

82

게시일: 2013년 12월 7일

옵션

The first one is Q7, part of the LCD backlight power supply

The second is C355, capacitor to ground for the bias voltage of MIC1

The first one is probably important, without it the backlight may be overloaded or have some other issue

The second one, it's ok

This is why I'm against prying the battery, it's dangerous not just because you may puncture it, but also risk causing damages to other components if you did not land the tool in the right place. Just use the pull tab, if the tab breaks, remove the logic board first, then pry against the metal case when trying to remove the battery. It's less likely to damage the logic board

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 3개:

That's very specific! Thank you for your reply. I hope the first one doesn't cause any problems.

Would I know right away? Everything seems normal for the LCD backlight.

Now that the battery is loosened up from the initial removal it comes out much easier with the tab. I will remember that in the future though, removing it first. I fixit should really suggest that instead. I know I'm not the only one that has damaged their logic board from prying.

Jordanb 의 2013년 12월 7일

I didn't notice at first, you were trying to replace a transparent back case? Looks awesome but seems to hamper signal reception a little bit. Does the GPS still works accurately enough to ensure navigation with the new case?

Tom Chai 의 2013년 12월 8일

Yeah I figured why not! I didn't notice any problems with reception and I don't use GPS very often. I only had it on for less than a week. There were some manufacturing defects in the plastic housing that I wasn't happy with. Mainly because the dimensions were off so it didn't fit into my case and the screen didn't fill up the opening snugly so it was prone to allow dust and things in. I went back to the original housing but I swapped out the buttons from a silver ip5 for some modification!

More pics of the plastic housing:

http://i.imgur.com/b1yrVHv.jpg

http://i.imgur.com/iWAmt28.jpg

Silver buttons!

http://i.imgur.com/6PQy28r.jpg

Jordanb 의 2013년 12월 8일

댓글 달기

That's very specific! Thank you for your reply. I hope the first one doesn't cause any problems.

Would I know right away? Everything seems normal for the LCD backlight.

Now that the battery is loosened up from the initial removal it comes out much easier with the tab. I will remember that in the future though, removing it first. I fixit should really suggest that instead. I know I'm not the only one that has damaged their logic board from prying. — Jordanb
I didn't notice at first, you were trying to replace a transparent back case? Looks awesome but seems to hamper signal reception a little bit. Does the GPS still works accurately enough to ensure navigation with the new case? — Tom Chai
Yeah I figured why not! I didn't notice any problems with reception and I don't use GPS very often. I only had it on for less than a week. There were some manufacturing defects in the plastic housing that I wasn't happy with. Mainly because the dimensions were off so it didn't fit into my case and the screen didn't fill up the opening snugly so it was prone to allow dust and things in. I went back to the original housing but I swapped out the buttons from a silver ip5 for some modification!

More pics of the plastic housing:

http://i.imgur.com/b1yrVHv.jpg

http://i.imgur.com/iWAmt28.jpg

Silver buttons!

http://i.imgur.com/6PQy28r.jpg — Jordanb

iPhone 5

Broke a few things on the logic board, how serious is it?

답변 1개

귀하의 답변을 추가하세요