주요 콘텐츠로 건너뛰기

Black and silver single cup coffee maker with water reservoir on the left hand side. K40/K45.

98 질문 전체 보기

Not taking in or putting out water

My Keurig slowly started brewing less & less coffee. Finally last night it completely stopped putting any amount of liquid out. Did the paper clip thing and no changes. As far as I can tell it is not taking in any water either. I have been trying to DeScale it all day & it just seems like it is not taken in any water. When I took the lid off of the Water Tank, just to see what was going on, it is putting water back into the water tank. Any other advice?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 2
댓글 1개

This is the exact same thing mine is doing! I am ready to throw mine out and go back to my old coffeemakers.

댓글 달기

답변 1개

가장 유용한 답변

I was having the same problem. I tried all of the things suggested on different sites (the paperclip thing, blowing compressed air in the hole that is spitting the water back in to the tank) nothing worked. I decided that I had nothing to lose, so I took off the plastic piece that is on the arm (the part that you lift up to put the K-cup in). To take it off I had to first open up the arm like I was putting in a k-cup and unscrew the two screws that were on the roof. I then closed the arm and unscrewed the screws that were holding the handle on. After this I had to wiggle the plastic piece that covers the arm around until it came off. I thought it would break but it didn't. When I got the plastic top off I could see the hose that takes the water from where it heats to put it through the K-cup. I couldn't figure out how to take the hose apart so I started squeezing the portion that was closest to the front, this made it spit out water. I then turned the keurig on and ran a cup through and it worked. Im guessing there was some blockage in the hose that was dislodged when I squeezed it. Hope this helps!

해당 답변은 도움이 되었습니까?

점수 1

댓글 2개:

Thanks Zoie for your insight .. it helped just as you described. Coffee Time LOL.

Took a while to get the hood off and back on but it worked. Wuld have help having a magnetized screw driver to put those small screwws back but managed with a piece of tape. Thanks.

댓글 달기

귀하의 답변을 추가하세요

Jennifer Bartz 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 1

7일 전: 2

30일 전: 7

전체 시간: 3,052