옵션

What do I replace the original thermal materials with?

I am reinstalling my recently repaired logic board in my G3 900mhz iBook 14". The original thermal heat transfer materials on the heat sink were two preformed squares, the larger was a blue foam looking square, the other smaller one was gray and seemed to be a more solid version and consistency of thermal paste. Can I use the normal Arctic Silver paste for the installation or do I need to find the same type of original squares?

Thanks,

Randy

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 2

댓글 2개

Good question +

rj713 의 2010년 8월 6일

Thank you, I'll give that a go.

Randy

randy3833 의 2010년 8월 6일

댓글 달기

게시일: 2010년 8월 6일

옵션

Arctic Silver Thermal Paste will work great om the heat sink in your laptop.

해당 답변은 도움이 되었습니까?

예 아니요

점수 2

댓글 2개:

Thanks. Do you have a recommendation for the thickness of the paste? The iFixit instructions say to spread a thin layer. The original materials were fairly thick, maybe up to 1/16th of an inch.

randy3833 의 2010년 8월 6일

My experience in the matter is that it's better to have a bit too much than a bit too little. You just really need to make sure you don't have any that comes out over the edges / spills out when you reapply the heat sink. 1/16 " sounds fine to me, I just like to make sure I can't see the processor any more through the thermal compound.

Taylor Arnicar 의 2010년 8월 6일

댓글 달기

iBook G3

What do I replace the original thermal materials with?

답변 1개

귀하의 답변을 추가하세요