Apple iPhone 5s는 2013년 9월 10일에 발표되었습니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 은색, 금색 및 스페이스 그레이.

3836 질문 전체 보기

Screen not working properly after replacement

Recently I dropped my phone, and it was really broken and actually even bent a little bit, so I had my friend replace it.

The replacement went well, but it becomes very unresponsive at times... When typing usually it registers the wrong key, screen starts going crazy and tapping everywhere (without me touching it), but it's at random times. Sometimes it works really well and sometimes it just goes ham. For some reason locking the screen and unlocking it fixes it, but not always.

Any solutions? Its driving me crazy when i'm trying to text someone or search up a video on YouTube it just goes crazy as mentioned before.

답변되었습니다! View the answer 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
의견 추가하세요

US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

상점 둘러보기

3개의 답변

선택된 해법

You could have:

  • an incorrectly installed replacement screen.
  • a poor quality replacement screen.
  • a damaged logic board due to the bent housing

It's hard for us to say, you will have to troubleshoot this and isolate some variables. Try to find a known-good screen or try it in a working phone. Double check your connections and insure the right screws are in the right place. Always disconnect your battery before removing the screen.

If the logic board is still bent or warped, that may also be the problem. Do some tests and get back to us or have it looked at by a qualified repair shop.

해당 답변은 도움이 되었습니까?

점수 2

댓글:

Thank you, I will try your possible solutions.

의 답변

의견 추가하세요
가장 유용한 답변

This is usually due to either a bad screen or a damaged logic board like Minho said probably in the touch screen circuit related area of the board.

This may sound stupid but try putting a tempered glass screen protector and see if the issue still occurs.

I had a iPhone 5 screen replacement done once and it would stop responding to touch input and do ghost touching. I put a tempered glass screen protector on and it has worked perfectly fine afterwards.

My guess is that the aftermarket LCD has it's digitizer touch screen layer too close to the glass probably due to the glue being used being too thin and the only way to get the touchscreen to work fine would be putting on a tempered glass screen protector to increase the distance between the touch screen layer and your hand touching the screen physically so that it does not have issues of it being too close.

Pretty much only aftermarket LCDs have this issue as they are pretty much copy LCDs. Refurbished ones would rarely have this issue depending on the quality of the refurbisher.

해당 답변은 도움이 되었습니까?

점수 3
의견 추가하세요

Sometimes these touch failure disapear when you put a screen protector on the front, at least you can try that.

해당 답변은 도움이 되었습니까?

점수 0
의견 추가하세요

귀하의 답변을 추가하십시오

anderpeenemaa 가/이 대단히 고마워 할 것입니다.
조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 5

전체 시간: 139