해결됨: iPhone 6 plus boot loop after screen repair - iPhone 6 Plus

iPhone 6 plus boot loop after screen repair

Hi Everyone!

We had a iPhone 6 plus come in yesterday with a bad lcd, you could still see the lock screen, but there were lines and black spots on the screen.

I did a simple screen replacement n it, even unplugged the battery before repair, when I went to turn the phone back on, it started boot looping. Ive tried everything, from unplugging camera flexes to another battery.

Ive also tired updating thru iTunes, however, when ever it gets to the point where it loads the software on the phone, it boot loops again.

Any ideas??

게시일: 2017년 7월 26일

옵션

A boot-looping device can be caused by many things.

Try these things (if you haven't already) to see if anything helps:

Try a hard reset (Home & Power button for 10 secs)
Use a genuine Apple Lightning connector
Use a genuine Apple charging brick and let it charge overnight
Try to connect it to different computers (mac/pc if possible) with an updated iTunes
Put the phone in recovery mode (search DFU Mode). Careful, this can reset your data
Use 3uTools for putting it in and out of Recovery Mode
Use 3uTools to flash the firmware (you can't downgrade)
Check the condition of all the flexes (with magnification)
Disconnect the Front Camera Ribbon from the logic board and reboot your phone
Disconnect the screen assembly completely and see if iTunes will recognize the phone.

Otherwise, you may have a logic board issue. A shop that also does micro-soldering can go deeper if the problem is not modular in nature.

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 달기

iPhone 6 Plus

iPhone 6 plus boot loop after screen repair

답변 1개

귀하의 답변을 추가하세요