기기를 수리하세요 커뮤니티 상점

2014년 9월 19일에 출시된 이 4.7” 스크린 iPhone은 iPhone 6 Plus의 작은 버전입니다. 모델 번호 A1549, A1586 및 A1589로 식별됩니다.

4994 질문 전체 보기

옵션

No backlight after unlock phone (backlight work during boot)

Hi guys,

recently i repaired iPhone 6 water damaged.

I replaced PMIC, after then phone boot but there are not backlight and touch. I replaced:

- backlight IC

- backlight capacitors

- touch ICs - MESON, CUMULUS

- LCD IC - CHESTNUT

Now after press power button, phone boot with backlight and work normal. When i lock phone, LCD goes off, but when i want unlock phone there are not backlight. Touch and LCD work.

My question is:

Where can be problem? It look, backlight driver do not receive ENABLE signal after booting and do not want work.

Can be here problem with

45_AP_TO_PMU_AND_BL_DWI_CLK

45_AP_TO_PMU_AND_BL_DWI_DO

?

For what is there this bus?

Sorry for my bad english :)

Thanks

@refectio

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

Those two lines are part of the I2C bus. You will want to check them to insure they are not shorted. I would also look at pin B1 of U1502. That is the Hardware Enable pin. I don't know enough about the internal logic of these IC's to say what could be causing this.

해당 답변은 도움이 되었습니까?

예 아니요
점수 2
댓글 달기

옵션

I fixed so many backlights specially on 6 and 6s. Normally it's filter

But recently I d given iPhone 6s with very low backlight

Checked all caps, filter, diod, coil etc. Everything seemed fine so I changed backlight ic(u2040) no luck

And than I changed main pm ic and problem has gone.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 2개:

How do you know that you must replace PMIC? Should i use multimeter?

의

yes check all the voltage and most importantly recistance of the components.

But you said you have changed it didn't you?

But again your phone is the water damage. Could be anything man.

Have you checked any short?

의

댓글 달기

귀하의 답변을 추가하세요

Tomas 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 4

30일 전: 4

전체 시간: 478