기기를 수리하세요 커뮤니티 상점

A Kenmore residential washing machine made between 2001 and 2009. Identify the age of your Kenmore washer with its serial number.

79 질문 전체 보기

옵션

Washer restarting after load is done

Washer will go though a full load then in about 5 mins or less it will start washing again all ready did a cycle check by turning the dial and going through that and still does it is there a way you can do a factory reset on it or what else can we do

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 2
댓글 1개

I have this problem too. My Kenmore will show cycle complete but if left unattended it will go to sensing and start filling up again. If you unplug it, it will resume sensing after you plug it in. I have to do a 3sec press to cancel.

Error codes show no problem. Had previously cleared block from drain pump. I then did a recalibrate and ran auto test with no errors. What gives?

의

댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

To do a factory reset, unplug it for five minutes.

Next I would replace the timer . That failing, you're looking at the control board.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1
댓글 달기

귀하의 답변을 추가하세요

Glenn Didier 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 9

30일 전: 42

전체 시간: 4,219