주요 콘텐츠로 건너뛰기

2015년 9월 25일 출시. Model A1688/A1633. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

2690 질문 전체 보기

iPhone wont charge with original cable and its discharging very fast

So I bought iPhone which came with original battery that said it had 80% health but I could use it maximum 30 min and replaced it with replacement battery but life on this battery isnt very good either. If I leave disconnected from charger at night in the morning its dead so even when its not doing anything its discharging. When the battery drops below 25% its start to lag and its unusable actually and sometimes this percentage at when its starts to lag varys, also now it lags when it has 60%. Does anybody know what could it be?

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 2개

선택된 답변

Sounds like charging chip if it wont charge with original cable (make sure that cable works on another iPhone) but the lagging sounds like bad quality batteries.

해당 답변은 도움이 되었습니까?

점수 3

댓글 3개:

Do You maybe know the name of that chip?

It would be called U2 Tristar charging IC

Thank You very much! I found that some people replace U4, do You maybe know what he is?

댓글 달기

Tristar failure is a really good candidate for this problem, or you may have some corrosion on the logic board that is causing a partial short resulting in a low level current leak. Either way—these are microsoldering problems and it is time for a trip to your friendly local microsoldering/board repair shop.

해당 답변은 도움이 되었습니까?

점수 2

댓글 1개:

Well I was thinking of replacing it myself because I do know to solder with hot air gun so maybe I will give it a try on broken phone first then on my, thank You!

댓글 달기

귀하의 답변을 추가하세요

Electro Discover 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 98