기기를 수리하세요 커뮤니티 상점

Repair guides and support for your Samsung TV.

2612 질문 전체 보기

옵션

Won’t turn on, red light flashes 6 times

My Samsung UN60H6350AF tv just wouldn’t turn on one day. The red light blinks 6 times then stops. There is no sound or picture. My condo does have questionable electricity with possible power surges. I tried to unplug it, hold the power button, wait for a few minutes, then power back on but nothing happened. I have unplugged all other cables from the tv. I think I’m going to need to open it up but need repair/troubleshooting guidance and tips for safety.

Block Image

Block Image

Block Image

Update (08/04/2019)

Ok here are some pics and I have a multimeter. What do I do next?

Block Image

Block Image

Block Image

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 2
댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

@ryguy19 yup, time to open it up. This could be a power board or main board issue. since you have no audio or video it is unlikely that this is a bad backlight array. Once open, check the power board connector to the main board for the proper voltages (all are DC) let us know what you find. Samsung does not use post blink codes but this could be a main board issue. Once apart, take a few good pictures and post those with your question so we can see what you see 기존 질문에 이미지 추가하기

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 9개:

How exactly do I check the power board connector to the main board for the proper voltages? Sorry I’m new to all of this.

의

Once you have your back open post some good pictures of your boards. I will mark where to measure and what voltages to expect. you will need to get/have a multimeter.

의

Ok, I used the multimeter to measure the voltages on the power board. Here is the key and the voltages I measured:

2. UD (2.28v) 1. A13 V (12.82v)

4. BLU_ON (3.26v) 3. A13 V (12.82v)

6. PS_ON (4.46v) 5. A13 V (12.82v)

8. GND (0v) 7. A13 V (12.82v)

10. GND (0v) 9. GND (0v)

의

Those look to be okay. Sounds like your power board is ok which would leave the mainboard as the culprit. Disconnect the wire from the power board to the main board. See if your backlight comes on

의

No backlight when I unplug the wire from the power board to the main board. However, with the cord plugged in I see the red light for the digital audio out(optical) is on (on the main board)and there are 3 blue lights on the T-con board that are on. Does this mean I’m getting power to those two boards? @oldturkey03

의

댓글 4개 더보기

댓글 달기

귀하의 답변을 추가하세요

ryan brown 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 4

7일 전: 21

30일 전: 74

전체 시간: 2,615