| 624,103 | 평판 |
| 19,229 | 해결책 |
| 103 | 안내서 |
| 2010년 09월 29일부터 회원 | |
Semi-Retired
Nine years is a long time. After some debates with friends etc., I’ve made the decision to take a step back. Thank you to all those great people on here that have made this a lot of fun. So, as of this time I consider myself as semi-retired. :-)
I will continue to support organizations like https://repair.org/stand-up/ to fight for our right to repair.
| 이벤트 | 개수 | 델타 |
|---|---|---|
| 게시물이 추천되었습니다 | 32975 | 325138 |
| 답변 승인함 | 9687 | 246078 |
| 누군가 귀하의 안내서를 완성하였습니다 | 826 | 19454 |
| 귀하의 안내서 링크를 포함한 추천 게시물 | 3113 | 17173 |
| 관리자가 귀하의 안내서를 승인하였습니다 | 99 | 10120 |
| 누군가 귀하의 안내서를 좋아요 하였습니다 | 722 | 6499 |
| 안내서를 번역하셨습니다 | 15 | 734 |
| 승인된 답변 | 3 | 30 |
| 게시물이 비추천되었습니다 | 20 | -120 |
| 게시물을 비추천하였습니다 | 502 | -1004 |
No, they do not. Strictly solid state
jennifer Mooney that is not necessary. I have replaced the spark plugs on “the Beast” numerous times and still have the original coil packs (240,000 miles and no issue;)
Just like any other power supply, don’t stick your fingers into it. The caps will remain charged for a while. Discharging the capacitors will eliminate all danger.
@solly90
Fuse= (watts/volts)X1.25
Watt = Amps x Volt
Watt = .9 X3.7
Watt = 3.3
Fuse = (3.3/3.7)x1.25
Fuse = 1.125
~1.5 Amp fuse will work. Measure the width and length of your fuse to determine the package size and check on places like Mouser or Digikey for a replacement
rsbrogna I believe the jumper had to do with the counter plus it was easier for me to do it that way. The only point I can think of where to test is at the fuse on the PCB.
@dave7777 nope. Place a rag under the hose before you take it off so it does not leave to much of a mess. Check the fluid after.
Antoinette Noelien glad this guide worked for you and that you got your TV back.
@ifixitjdunne1 Hey Jim, you are welcome. Glad we could help you save some money. :-)
Jonathan DeMattia
you may have “peeled of the pads. We would need to see your work to give you more of an idea. You want to move this to “Answers” and in there add some pictures to your question.
@pandrsmith2 where are you stuck with it? You did recognize it is a left handed thread? If it is really stuck on it, it may be easier to remove the whole motor assembly and use a Dremel like tool to cut the blade gear…
8페이지 중 1페이지
다음