기기를 수리하세요 커뮤니티 상점

2015년 9월 25일 출시. Model A1688/A1633. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

2692 질문 전체 보기

옵션

After battery replacement, home button will not function!?

I recently did a battery replacement on my 6s with a ifixit kit, at first everything seemed fine upon reassembly and power on, but then I realised that my home button gave me no response, and upon startup/power on iphone came up with warning message saying “touch id not available”. Is someone able to help me with this? I did not mess with the area around the home button so not sure how this could have happened. Any help appreciated! Thanks!

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된

옵션

First check to make sure the cables are connected all the way, Next I would check each cable for the slightest bent connector or tear in the cable. May have to use a magnifing lens, even a slight wrinkle in the cable can cause damage.

If you used any heat to separate the screen you may could have damaged the chip connected to the home button.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 3개:

Hi, is possible i may have slightly bent connector, but not ripped, is it possible to replace this part yourself?

의

If the connector on the logic board has a bent connector then you can replace it if you can micro solder, if you are not able to then you will have to send it out to have it done. If its a bent connector on the flex cable then yes you can replace it yourself.

의

Yeah, if the connectors are bent on the logic board or the home button cable then you might have to send it out. If one of the screen connectors is bent, you probably will need a new screen.

의

댓글 달기

귀하의 답변을 추가하세요

Brayden courtney 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 6

전체 시간: 56