해결됨: Screen isn’t sitting flush where the display cables are sat - iPad Air Wi-Fi

Screen isn’t sitting flush where the display cables are sat

After completing a digitiser replacement, when laying down the glass, it does not sit flush with the frame of the device. It rises up slightly where the cables are, and no matter what I try, I cannot get it to sit flush. A picture of where the cables are sat now is attached.

게시일: 2020년 8월 29일

옵션

It’s hard to tell from your picture but it appears that the flex on the digitizer hasn’t been adhered properly. Take a look at this image (Step 37) from this guide. Also look at the old digitizer for reference. The rest of the flex is bent over on itself and adhered to the back of the digitizer.

There should only be the two narrow flexes going from the digitizer to the logic board.

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 1개:

Ah yes that’s probably it, I’ll try that tomorrow

Charlie While 의 2020년 8월 29일

댓글 달기

iPad Air Wi-Fi

Screen isn’t sitting flush where the display cables are sat

답변 1개

귀하의 답변을 추가하세요