기기를 수리하세요 커뮤니티 상점

2017년 9월 22일 출시. Model A1863, A1905. GSM 또는 CDMA / 64 또는 256 GB / 금색, 은색 및 스페이스 그레이.

873 질문 전체 보기

옵션

Reboot loop after battery change. Won't connect to a computer

Hello

So about 3 months ago I changed the battery on my iphone 8. Everything was working fine for 2 months and then it stopped charging. Since the new battey was faulty I got a new one. I turned on the phone while it was open, just to get some photos on my computer, turned it off, disconected the battery and set the phone aside till a new seal for the screen arrived. I then put the phone together and now is on a bootloop and it won’t connect to any computer. I tryed everything the internet has to offer. I just can’t get it out of the boot loop and for it to connect to a computer.


Sorry for my bad english.

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 달기

답변 3개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

If you are sure the battery is okay the next thing to rule out would be the top flex. See if it boots with it disconnected.

If it still boot loops you have probably caused some pry damage around the connector or to the connector itself. Make sure the connector pins are not pushed into the plastic.

The most common problem for the 8 after a screen or battery change is nudged components. You will need to examine the area under some magnification. If the pins on the connector look alright it will defiantly be one of the other components.

Block Image

If they have been nudged you will need a reputable repairer to fix the problem as it will require microsoldering and maybe some jumpers installed.

해당 답변은 도움이 되었습니까?

예 아니요
점수 2
댓글 달기

옵션

This could mean either two things, or you have yet another bad battery, or you have a damaged logic board. If it’s possible I would contact the store again where you bought the battery and go for a refund and buy a better quality battery elsewhere. Also double check if all the connectors are seated correctly, because if the battery isn’t properly being detected you can also end up in a bootloop.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

옵션

First thing to try is a new battery, put a new battery first. You got to rule things out and this is the first step.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 2개:


Battery is 100% good. I tried a few diffrent batteries. also the conectors are all fine and seated correctly.

I do alot of work like this. Mostly screens, batteries, speakers and so on.

This phone is the first one I can’t figure out

의

Next time use the comment section :-).

If indeed the battery is OK, and all the connectors are OK, I'm afraid it might be a logic board issue.

의

댓글 달기

귀하의 답변을 추가하세요

filipbabic 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 1

7일 전: 15

30일 전: 45

전체 시간: 658