Replacing Right Shoulder Button

Question

Nintendo Switch Lite

조이콘 컨트롤러와 약간 더 작은 스크린이 통합된 보다 합리적인 가격의 순수 핸드헬드 버전의 Nintendo Switch의 게임 콘솔입니다. 2019년 9월 20일 출시.

175 질문 전체 보기

Brandon Paul @brandonpau29420

평판: 11

게시일: 2023년 6월 1일

옵션

Replacing Right Shoulder Button

Hello!

I was performing a stick swap to fix a drifting joystick on my switch lite. During that, the exposed rubber for R button ripped off when removing the plastic bumper. I've only ever soldered a couple things, and I'm having issus getting the solder to melt. I've got new buttons, but the repairs I see are all for joycons and they don't seem to have issues with the solder not melting.

Has anyone performed this kind of repair or have any advice to get this button swapped out?

A photo of the broken button is attached.

Any help is greatly, greatly, appreciated.

Thanks!

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 0

댓글 달기

답변 1개

선택된 답변

[deleted]

평판: 551

9

8

13

게시일: 2023년 6월 2일

옵션

What solder are you using? Use 60/40 leaded. Also what soldering iron are you using? Add a pic if you can. Also use flux. It helps with the transfer of heat allowing the solder to melt.

해당 답변은 도움이 되었습니까?

예 아니요

점수 0

댓글 2개:

Thanks for the reply! I had my soldering iron set too low. I originally found 260° C was a good temperature, but after looking again I saw 360° C was recommended. I changed my iron to 360° C and I was able to melt the solder and get the button off. I had an issue with the through holes, but since they were only there as supports, I was able to remove (tear) the button portion from the support mounts. After that I resoldered a new button the the data pins and supports mounts and everything has been working great for about a week now. If anyone else needs to do this, make sure you resolder the button as close to the board as you can. The space to fit the shoulder button is very tight.

Brandon Paul 의 2023년 6월 7일

Hello, for the replacement part? Does a joy con part works as well? (The bumper R solder part)

john harrington 의 2023년 11월 5일

댓글 달기

Thanks for the reply! I had my soldering iron set too low. I originally found 260° C was a good temperature, but after looking again I saw 360° C was recommended. I changed my iron to 360° C and I was able to melt the solder and get the button off. I had an issue with the through holes, but since they were only there as supports, I was able to remove (tear) the button portion from the support mounts. After that I resoldered a new button the the data pins and supports mounts and everything has been working great for about a week now. If anyone else needs to do this, make sure you resolder the button as close to the board as you can. The space to fit the shoulder button is very tight. — Brandon Paul
Hello, for the replacement part? Does a joy con part works as well? (The bumper R solder part) — john harrington

Nintendo Switch Lite

Replacing Right Shoulder Button

답변 1개

귀하의 답변을 추가하세요