기기를 수리하세요 커뮤니티 상점

모델명 A1707. 2017년 6월 출시, 이 MacBook Pro는 Kaby Lake 프로세서 최대 2.8 GHz 쿼드코어 Intel Core i7 프로세서와 Turbo Boost 최대 3.8 GHz를 사용합니다.

327 질문 전체 보기

옵션

Trackpad is clicking but the trackpad moves by itself!

Recently I bought a MacBook Pro 2017 A1707 trackpad is clicking but it doesn't track when you move your finger.

It moves by itself and sometimes opens the Lunchpad which is wired. I replaced the trackpad but it was the same then I changed the top case it didn't change anything.

Update (08/22/23)

Block Image

I checked them already, It has 12.60 V. I'wondering how it moves by itself.

Update (08/22/23)

Block Image

I found the pin 41 it is broken but it is ground. what can I do??

Update (08/22/23)

Block Image

It is ACT GND

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 1개

@armin1 anytime you have a disconnected pin etc.it is advisable that you repair this. Even GND is needed to function and missing ground can give weird results. I suggest you fix that connection and re-evaluate

의

댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

If you replaced the trackpad and the top case and the trackpad cable and you're still unable to use the trackpad properly then there is probably a larger issue with the main logic board or software. Have you tried reinstalling your OS? If the issue persists on a device with a new top case, trackpad, trackpad cable, and clean OS installation then the problem is almost definitely due to a fault on the main logic board. Good luck!

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 4개:

"I wanted to reinstall the OS, but when I press the option key to choose a drive or flash drive, the trackpad is still experiencing the same issue. Do you think it will be okay if I proceed with the installation process??"

의

I installed a fresh macOS, but it has the same problem.

의

which part of the board needs to be checked?

의

I'm not sure where the issue would likely be. I'd recommend removing the logic board carefully and then fully inspecting it for any signs of damage. Also, when you replaced the top case did you replace the battery as well?

의

댓글 달기

옵션

@zpl @armin1 here is the Trackpad connector diagram Check those pins on your board. Interesting to see that the trackpad has its own fuse. See if you have the required 12.6V on that. F4500 is just above the connector L4500 and C4500 are on the opposite side. Pin 1 of the connector is the one on the bottom left of your logic board.

Block Image

This is not as to interfere with the troubleshooting by @zpl but just to augment it.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 1개:

Nice! Thanks!

의

댓글 달기

귀하의 답변을 추가하세요

Armin 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 2

전체 시간: 55