기기를 수리하세요 커뮤니티 상점

Repair information for Whirlpool dishwashers.

156 질문 전체 보기

옵션

GU2300XTVS0: Random pattern on lights [Quiet Partner III]

Brand/Model: Whirlpool, Quiet Partner III, GU2300XTVS0

Dishwasher started to have some issues a few months back when we were not able to change cycle settings. This was not an issue since we always run on 'Normal' and 'Heated Dry'. However, a couple of days ago I noticed lights on right side of the panel were randomly flashing for a quick second. I just ignore it because cycle was running normal.

Now dishwasher wont start unless I do these steps:

1. Reset it by turning power off and back on (from electric board switch) when door is open

  1. Closing door (a noise similar to draining will start)
  2. Pushing cancel button (noise will stop)
  3. Pushing start button (and a cycle start)

Cycle will clean dishes as normal with heated dry, like there were no issue. However if I want to start another cycle, I'll need to do above steps again.

Also lights will show very random patterns during the whole cycle as shared in the images.

Block Image

Block Image

Block Image


What do you suggest?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 1
댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

Hi @oscarcallau

Looking at the tech sheet for the dishwasher the symptoms appear to indicate a faulty keypad.

Follow the steps as shown in the Checking Keypad Operation section (lower right half of p.2) and check if anything seems amiss

해당 답변은 도움이 되었습니까?

예 아니요
점수 2

댓글 2개:

Thanks @jayeff, I did the checking keypad operation, control is still working as expected, so this is a keypad issue.

의

@oscarcallau

Hopefully it may only be a diode problem or a corrosion problem and not that the panel needs replacing as they are not cheap.

If you decide to replace the panel search online for WPW10175347 to find suppliers that suit you best. Perhaps try and find one that has a good returns policy with only a small restocking fee maybe, so as to minimize the cost to you if the control panel is not the problem.

The part number is a replacement part number for the original part which was part number W10175347 which has been superseded as supposedly it is no longer available. This part number may be on a sticker on your panel, just so that you're aware of why the "slight" change in the numbers i.e. from W.... to WPW......

Although searching online for either number still gives results for suppliers

의

댓글 달기

귀하의 답변을 추가하세요

Oscar Callaú 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 1

7일 전: 1

30일 전: 12

전체 시간: 37