주요 콘텐츠로 건너뛰기

이 문서에서 해답을 찾아보세요

여러분이 직접 읽을 필요 없도록, 저희는 ‘ 10’ 의 모든 페이지를 이미 읽어보았습니다. 지금 바로 질문하고 답변을 받아보세요.

G1 Remote Control

10 페이지 · 7.12 MB · PDF

G1 Remote Control

User Manual V1.3

Image

Robots

Unitree

This product is a civilian robot. We kindly request that all users refrain from making any dangerous modifications or using the robot in a hazardous manner.

Please visit Unitree Robotics Website for more related terms and policies, and comply with local laws and regulations.

Introduction

The R3 remote control is part of the G1 remote control module, and the remote control handle is equipped with a digital transmission module and a Bluetooth module. The robot and the remote control are bound through the Unitree Explore App, and once successfully bound, they can be connected upon powering on. It can control the robot to achieve 3-axis posture and 3-axis position stability when standing, and can also control the robot to move forward, backward, left, right, turn in place, and walk according to certain rules (straight line, circular, linear, rectangular) on flat ground, as well as go up and down slopes/steps. The remote control handle adopts a more ergonomic design for easier grip, providing a more comfortable feel.

Parts Name

Image

[3] [2] [1] [4]

Image

[2] [1] [6] [7] [8] [9] [10] [11] [12] [13][14][15]

Image

[5]

Image

[2] [1] [11][12]

[4] Key R1/R2

[5] Type C Charging Interface

[9] F1 (Function Setting Key)

[12] Power Button

[15] START

Technical Specifications

ParameterSpecificationRemarks
Charging Voltage5.0V
Charging Current700mA
Lithium Battery Capacity780mAh
Communication ModeData Transmission Module, Bluetooth
Running Time5h
Remote Control DistanceAbove 100mOpen Environment

Install the joystick

Step 1: Take out the joystick. As shown in the picture, use your right hand to pull out the remote control smoothly and slowly, and remove the two joysticks from the storage slot.

Image

SELECT F1 START

Step 2: Install the remote control. As shown in the figure, secure the remote control to the remote control in a clockwise direction and tighten it.

Image

● If you need to store it, please remove the remote control and place it in the storage slot.

Remote Control Handle Rocker Calibration

Hold the remote control without touching the rocker, press the upper buttons F1 and F3 on the remote control and release them at the same time. At this time, the remote control will emit a continuous "beep-beep-" sound (1 time/sec) to indicate that it has entered the calibration mode. After entering the calibration mode, the users need to turn the left and right rockers to full rudder and rotate several times until the sound of "beep-beep-" stops, and the calibration is ready. Press F3 once to make the calibration take effect and complete the calibration.

Attention! When

iFixit에 무료로 가입하여 전체 문서를 읽어보세요 (10 페이지)

봇을 차단하고 iFixit을 인간 사용자를 위해 유지하기 위해 무료 계정 등록이 필요합니다.

조회 통계:

지난 24시간: 3

지난 7일: 14

지난 30일: 44

전체 시간: 75