SmartVP™

Installation Guide

Welcome to SmartVP

This guide will take you step-by-step through the installation process. If you need help or have any questions, please call Purple Customer Care at 877-885-3172.

SmartVP Check List

Before you get started, you need the following:

Internet Connection

Make sure you have an Internet connection using an Ethernet cable.

图

WiFi

Flat-Screen TV with an HDMI Port

To use SmartVP, an open HDMI port on your TV is required.

HDMI

Broadband Connection

512 kbps

Because SmartVP uses HD video, a minimum of 512 kbps of upstream/downstream speed is required. SmartVP will adjust to lower speeds, but the higher the connection, the better.

Box Contents

Purple SmartVP Device Power Adapter 1 Power Adapter 2 Power Strip HDMI Cable Ethernet Cable Remote Control

1 Plug in your SmartVP

Power

Power Adapter 1: Plug the smaller end into the 5V DC outlet on your SmartVP. Plug the larger end into the Power Strip.

Power Adapter 2: Plug the smaller end into the Power outlet on your SmartVP. Plug the larger end into the Power Strip.

Turn Power Strip on.

IMPORTANT: Both power adapters must be connected to SmartVP and the Power Strip. For SmartVP to work, the Power Strip must be ON.

🎸

2 Connect SmartVP with your TV

Plug the green end of the HDMI Cable into the HDMI outlet on the SmartVP and plug the red end into the HDMI port located on your TV.

plug the red end into the HDMI port location your TV.

Adjusting the Mounting Device

↑ ↓

Adjust the slide/swing foot to fit your TV.