Sleepytroll Baby Rocker User Instructions

sleepytroll

sleepyroll

Congratulations on purchasing your new Sleepytroll Baby Rocker! For the latest information and user instructions in other languages visit www.sleepytroll.com

Introduction

Sleepytroll is designed to attach to prams, strollers / cribs & bouncers (using an adapter) and to gently rock your baby to sleep. In Basic mode it will rock for 60 minutes (up to 3 hours using our App) before turning off. In Sensor mode Sleepytroll will monitor sound and movement and start rocking when your baby becomes restless.

Safety information

Please read these user instructions before using the product, and keep for future reference. Please read adaptor manuals carefully when using Sleepytroll with adaptors. Symbols used:

This product is intended to aid your child in sleeping / relaxing and is not intended to replace a carer, or be used over an extended length of time.

△! = Warning - Risk of personal injury

i = Notice - Risk of damage to the device

Warning - This product is not a toy and should be used by adults only. Postion the product out of reach of the child and at a safe distance from your child when in use. Never position the product closer than 5cm or directly over your child. Charge out of reach of children.

Warning - Adult supervision is required, do not leave your child unattended.

Warning - Sleepytroll can produce a powerful rocking motion. This allows the product to rock large/heavy strollers & cribs. Always use the lowest setting that works with your stroller and child's weight combination and simulates your normal hand rocking. It is your responsibility to make sure that your child is comfortable with the rocking effect setting you choose, as a too powerful rocking might discomfort or harm your child.

The product should only be attached and used in vertical position. Usage while not hanging vertically will reduce the motor life.

Safety information continued

Warning - Charge only using the supplied cable & a USB power supply with an output rated 5V, marked with either of the following symbols: ☐ ☐ Risk of electric shock/fire!

Warning - Always lock the brakes on the pram/stroller before using the product. Using the product with brakes unlocked may cause the pram/stroller to move unexpectedly.

Warning - The pram/stroller should be positioned on a level/flat surface. Positioning on a slope may allow the pram/stroller to move unexpectedly.

Orient the product with the buckle towards your child (sound sensor is on this side) and position it out of your child's reach & at a safe distance during use (never closer than 5cm.)

The product should only be attached and used in vertical position. Usage while not hanging vertically will reduce the motor life.

MIN SCM

!

Warning - If using with a baby car seat (not recommended) outside of the car, or a bouncer seat, always place the seat on the ground. Never place the seat on a table, counter or other elevated location due to risk of fall.

Warning - Never put your baby to sleep in a product that is not intended for sleep. Sleepytroll should only be used with products like bouncer seats for short periods of time to keep your baby occupied or settled, but never for sleep or other extended use.

Notice: • Sleepytroll is tested to IPX4 (light rain). Do not use the product in prolonged or heavy rain.

• Using the product while it is not hanging vertically will shorten the motor life of your Sleepytroll.

• Do not open the product, it contains no user serviceable parts, and doing so will invalidate your warranty. If the product is not working correctly contact your place of purchase.

Positioning the product

Charging

1. Place your hand under the product to prevent dropping.

2. Orient the buckle towards your child (sound sensor is on this side) and position it out of your child's reach.

3. Pass the ladder strap around the handle and feed into the ratchett buckle until you hear a click.

4. Attaching the product

When the Battery Indicator light shows red, the batteries are running low and it is time to charge the product. Remove the Sleepyroll from the stroller/bouncer/crib. Open the Charger Door and insert the USB-C cable. The light on the Sleepyroll will blink red - yellow - green while charging, and show steady green once the batteries are fully charged (usually after 2.5 hours). Press the Charger Door closed when finished. The product will not function while charging. Charge the product fully before first use.

Warning - Do not charge outdoors, in wet/damp conditions, near heated surfaces, at temperatures below $ 0^{\circ} $C,