소개

Use this guide to replace a screen that is scratched, cracked, or broken.

Remove all the selector knob covers by pulling them off.
  • Remove all the selector knob covers by pulling them off.

댓글 쓰기

Using needle nose pliers, remove the washers from the four corner selector knobs.
  • Using needle nose pliers, remove the washers from the four corner selector knobs.

댓글 쓰기

  • Flip the device over. Using a Philips #2 screw driver, remove the fourteen 10.3 mm black screws holding the back panel in place.

댓글 쓰기

  • Carefully flip the device to the front making sure you secure the face plate and the chassis together.

  • Please use care in following the step above to avoid ripping the ribbon cables connecting the two sides.

댓글 쓰기

  • Rotate the device 180 degrees and carefully remove the face plate by slightly lifting the screen side towards you and then sliding the bottom out from under the keys.

  • Use care when doing the step above so that the ribbon connectors which connect the top of the chassis to the top of the face plate are not damaged.

댓글 쓰기

  • Using a Phillips #00 screwdriver, remove the four 8.9 mm screws.

댓글 쓰기

  • Using a Phillips #2 screwdriver, remove the one 9.8mm screw holding down the ground wire.

댓글 쓰기

  • Using two plastic opening tools, slide the black locking mechanism on the ZIF connector towards you. This will remove the ribbon cable connecting the motherboard to the screen.

댓글 쓰기

  • Lift the screen from either side, removing it from the board.

댓글 쓰기

결론

To reassemble the display, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Will Saba

회원 가입일: 2013년 01월 11일

352 평판

안내서 2개 작성하였습니다

Cal Poly, Team 20-6, Maness Winter 2013 Cal Poly, Team 20-6, Maness Winter 2013 회원

CPSU-MANESS-W13S20G6

5 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 3

지난 30일: 19

전체 시간: 1,213