소개

Removing the front cover gives access to lens housing, and allows removal of the top cover.

부품

부품은 필요하지 않습니다.

Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.
  • Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.

댓글 쓰기

Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.
  • Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.

댓글 쓰기

  • Remove the battery from inside the battery housing and set the cover aside.

댓글 쓰기

  • Remove the two 6.4mm screws above the lens aperture using a phillips #00 screw driver.

댓글 쓰기

  • Remove the 6.4mm screw from the inside of the flash bezel.

댓글 쓰기

  • Flip the camera upside down and remove the 5.4mm screw below the lens bezel on the front of the camera.

댓글 쓰기

  • Remove the 5.6mm screws behind the battery cover.

댓글 쓰기

  • Remove two 6.4mm screws on the latch mechanism on the right side of the camera.

댓글 쓰기

  • Remove the 6.4mm screw on the top of the inside edge of the battery hole.

댓글 쓰기

  • Starting at the flash, carefully pull the front cover away from the camera.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Mark

회원 가입일: 2011년 04월 20일

88 평판

안내서 5개 작성하였습니다

Cal Poly, Team 8-9, Regan Spring 2011 Cal Poly, Team 8-9, Regan Spring 2011 회원

CPSU-REGAN-S11S8G9

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 5

전체 시간: 2,080