소개
Replacing the command screen is relatively simple. You will have to pop off a few parts from the lid section of the printer in order to get at the back part of the command screen. Once you have access to the command screen and the attached chip, you can unplug a few wires and remove the screen with a philips-head screwdriver. After you have removed the screen, put in a replacement and close the printer back up. Good Luck!
필요한 것
-
-
Insert the spudger tool into the top lid in between the blue and the black panels.
-
Use this tool to pry the two panels apart
-
-
-
-
After these two panels are separated, set the top panel to the side for now
-
-
-
Unplug the two wires shown at the right of the command screen
-
-
-
Unscrew the four screws shown to detach the command screen from the printer
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 4명이 해당 안내서를 완성하였습니다.
팀
Cal Poly, Team 6-21, Maness Fall 2014 Cal Poly, Team 6-21, Maness Fall 2014 회원
CPSU-MANESS-F14S6G21
4 회원들
안내서 10개 작성하였습니다
댓글 2개
same question
