기기를 수리하세요 커뮤니티 상점

DYMO LabelPOINT 100 Keypad Replacement

필요한 것

  1. DYMO LabelPOINT 100 Keypad Replacement, Remove Label Tape Cartridge: 1 단계, 이미지 1/1
    번역하기

  2. DYMO LabelPOINT 100 Keypad Replacement, Remove Screws To The Access Panel: 2 단계, 이미지 1/2 DYMO LabelPOINT 100 Keypad Replacement, Remove Screws To The Access Panel: 2 단계, 이미지 2/2

    • Use Phillips #00 Screwdriver to remove the three screws that hold the upper portion of the access panel.

    • Remove the blade cutter assembly.

    • Use Phillips #00 Screwdriver to remove the last two screws located in the battery panel that holds the bottom portion of the access panel.

    번역하기

  4. DYMO LabelPOINT 100 Keypad Replacement, Remove Access Panel: 3 단계, 이미지 1/1

    • Gently remove the access panel from the right side of the device.

    • Some electrical wiring will be exposed and will not detach. Be careful not to damage any electrical wiring when removing access panel.

    번역하기

  5. DYMO LabelPOINT 100 Keypad Replacement, Removing Circuit Board: 4 단계, 이미지 1/2 DYMO LabelPOINT 100 Keypad Replacement, Removing Circuit Board: 4 단계, 이미지 2/2

    • Use Phillips #00 Screwdriver to remove three screws that hold down the circuit board.

    • Gently lift the bottom of the circuit board, revealing the keypad.

    • Be careful not to damage any components on the circuit board when disassembling.

    번역하기

  6. DYMO LabelPOINT 100 Keypad Replacement, Remove Keypad: 5 단계, 이미지 1/1

    • Remove the keypad from the front facing cover

    • When installing the new keypad, make sure all buttons are correctly set in each hole so that each button can be pressed.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 4명과 함께

Mike Dam

회원 가입일: 09/25/14

201 평판

안내서 2개 작성하였습니다

배지: 5

배지 +2개 더

팀

USF Tampa, Team 5-2, Mcgee Fall 2014 USF Tampa, Team 5-2, Mcgee Fall 2014 회원

USFT-MCGEE-F14S5G2

4 회원들

안내서 6개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 5

30일 전: 8

전체 시간: 1,077