난이도
보통
단계
11
소요 시간
10 - 15 분
- Side Panel 3 단계
- Optical Drive 8 단계
더 나은 이미지가 필요함
더 나은 사진은 해당 안내서를 향상시킬 것입니다. 사진 촬영, 편집, 또는 새로운 업로드를 도와주십시오!
마크업 사고
해당 안내서는 더 나은 마크업이 필요합니다. 일부 마크업 주석의 편집 또는 작성을 도와주십시오!
소개
Use this guide to replace the optical drive in your computer.
부품
부품은 필요하지 않습니다.
-
Locate the case cover latch on the back of the computer.
-
Using your index finger, slide and hold the cover latch down.
-
While holding the latch down, place your other hand flat on the side of the case and firmly shift the side panel to the left until it disengages.
-
Grab the edge of the panel and slide it away from the case until it is removed.
-
Locate the Optical Drive by finding it externally on the case.
-
Press and hold the two levers located behind the front panel.
-
While holding the levers down, swing open the front panel.
-
Swing the front of the case open until it separates from the main case.
-
Locate the Drive 1 cable and where it is connected to the motherboard.
-
Grasp the end of the Drive 1 cable connected to the motherboard and firmly pull upwards until it is removed.
-
Locate the end of the Drive 1 cable connected to the optical drive.
-
Grasp the cable and pull firmly to disconnect it from the optical drive.
-
Locate the screw on the optical drive.
-
Remove the 7.7 mm screw by using a Phillips #2 screw-driver.
-
Remove the optical drive by sliding it out of the front of the case.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 11명이 해당 안내서를 완성하였습니다.
팀
Cal Poly, Team 6-10, Regan Fall 2011 Cal Poly, Team 6-10, Regan Fall 2011 회원
CPSU-REGAN-F11S6G10
4 회원들
안내서 6개 작성하였습니다
