소개

Replace the interface buttons if they have fallen out or are worn out from usage.

부품

부품은 필요하지 않습니다.

Lay the monitor screen-down so the back screws are exposed.
  • Lay the monitor screen-down so the back screws are exposed.

  • Remove the four 11.9 mm Phillips #2 screws securing the stand to the back of the monitor.

댓글 쓰기

Gently lift and pull away the stand at a slight angle away from the monitor.
  • Gently lift and pull away the stand at a slight angle away from the monitor.

댓글 쓰기

  • Locate the two holes on the bottom of the monitor.

  • Insert a plastic opening tool or spudger into the holes and gently pry the plastic apart along the groove.

  • This task is much easier if two people pry simultaneously at each hole.

  • Continue prying along the entire edge of the monitor.

댓글 쓰기

  • When finished prying, the plastic will partially fall away from the rest of the monitor.

  • Do not try to fully remove the front frame yet. The frame is still attached to the buttons.

  • While holding the frames together, carefully flip the monitor over so it faces screen down.

  • Gently lift and remove remove the rear case from the monitor.

댓글 쓰기

  • Locate the green interface button board.

  • Remove the three 9.71 mm Phillips #2 screws holding the interface button board to the display bezel.

  • Lift the monitor interior away from the front cover.

댓글 쓰기

  • Behind the front panel of the plastic cover lies the button strip.

  • Remove the buttons by gently pulling up on the strip.

  • You may have to pry the plastic strip up with a prying tool or spudger to remove it.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Charley Grove

회원 가입일: 2011년 10월 10일

89 평판

안내서 1개 작성함

Cal Poly, Team 5-36, Amido Fall 2011 Cal Poly, Team 5-36, Amido Fall 2011 회원

CPSU-AMIDO-F11S5G36

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 4

전체 시간: 1,738