Parts

No parts required.

Make sure the toaster is unplugged before starting.
  • Make sure the toaster is unplugged before starting.

  • Turn the toaster upside down and remove the rubber feet.

Add Comment

Using a #2 Phillips head screwdriver, remove the four 12mm screws that attach the toaster shell.
  • Using a #2 Phillips head screwdriver, remove the four 12mm screws that attach the toaster shell.

Add Comment

  • With the dial facing you, push the toaster base up and away until the base is just over the lip of the shell. This will disconnect the browning dial from the rest of the toaster.

  • When reassembling the toaster, make sure that the back of the dial lines up with the slot both in position and orientation (the dial and slot are not perfect circles - they have a notch).

  • The only object holding the shell onto the toaster now is the grey part of the lever.

Add Comment

  • Reach under the shell and grab the back, white part of the lever.

  • Grab the grey lever between your index finger and your middle finger and pull.

  • Pulling too hard will break the mechanism that holds the grey handle onto the white lever.

  • Remove the shell.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 other people completed this guide.

Naomi Willis

Member since: 09/26/2012

56 Reputation

1 Guide authored

Team

Cal Poly, Team 2-8, Propen Fall 2012 Member of Cal Poly, Team 2-8, Propen Fall 2012

CPSU-PROPEN-F12S2G8

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 8

Past 30 Days: 26

All Time: 2,285