소개

The bottom of your Roomba can be easily removed by just removing the side brush, unscrewing four screws, and separating the plate from the device.

부품

부품은 필요하지 않습니다.

  1. Place your Roomba upside-down on a hard surface.
    • Place your Roomba upside-down on a hard surface.

    If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

    David Forrest - 답글

  2. While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
    • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Gently pull upwards on the brush to remove it.

    댓글 쓰기

    • Rotate the Roomba upside-down so the bottom is facing towards you.

    댓글 쓰기

    • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

    댓글 쓰기

    • Carefully lift the bottom plate.

    • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Deborah Newberry

회원 가입일: 2014년 01월 23일

551 평판

안내서 4개 작성하였습니다

Cal Poly, Team 13-14, Regan Winter 2014 Cal Poly, Team 13-14, Regan Winter 2014 회원

CPSU-REGAN-W14S13G14

4 회원들

안내서 13개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 5

전체 시간: 350