소개
Most of the components are inside of the unit. It is necessary to open the unit in order to access these components. Take care not to damage the ribbon cable connector upon removal. This guide will show you how to disassemble the unit.
필요한 것
-
-
Flip the device over.
-
Remove the four 10mm PH #2 screws by rotating the screwdriver counterclockwise, removing the screw from the housing completely.
FixBot에 문의하기
-
-
-
-
Separate the two cover pieces carefully by pulling apart the two cover pieces away from each other.
-
To reassemble the unit, follow these instructions in reverse order.
다른 한 분이 해당 안내서를 완성하였습니다.
팀
Idaho State University, Team S4-G1, Watkins Fall 2017 Idaho State University, Team S4-G1, Watkins Fall 2017 회원
ISU-WATKINS-F17S4G1
3 회원들
안내서 5개를 작성함
