소개

Directions for the removal and replacement of the RAM module in a HP 2000 - 2D22DX laptop computer. When adding more RAM, always replace the existing modules to ensure compatibility between modules.

부품

부품은 필요하지 않습니다.

  1. Flip the device over and locate the battery compartment. Slide the battery release latch to the left until the battery is detached from its slot.
    • Flip the device over and locate the battery compartment.

    • Slide the battery release latch to the left until the battery is detached from its slot.

    • A distinguishable pop will be heard when the battery is fully released.

  2. Slowly pull the battery out of its slot, being careful not to damage any of the connectors in the process. Slowly pull the battery out of its slot, being careful not to damage any of the connectors in the process.
    • Slowly pull the battery out of its slot, being careful not to damage any of the connectors in the process.

  3. US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  4. After battery removal, the RAM compartment cover is exposed. Locate the Phillips head screw seen in the second picture. It secures the RAM compartment to the plastic chassis.
    • After battery removal, the RAM compartment cover is exposed.

    • Locate the Phillips head screw seen in the second picture. It secures the RAM compartment to the plastic chassis.

    • Loosen the screw that is securing the RAM compartment with a Phillips #00 screwdriver.

    • The screw is permanently attached to the RAM compartment cover. Do not try to remove it completely.

  5. Once the screw is sufficiently loosened, gently unclip the RAM compartment cover from its slots in the plastic chassis. Pull the compartment door out and away from the chassis, exposing the black film covering the RAM module.
    • Once the screw is sufficiently loosened, gently unclip the RAM compartment cover from its slots in the plastic chassis.

    • Pull the compartment door out and away from the chassis, exposing the black film covering the RAM module.

  6. Move the black plastic film to the side to locate the RAM slots. Locate the metal clips holding the RAM card in place. Using your fingers, push the metal clips out and away from the RAM module until the RAM module pops up at a 45 degree angle.
    • Move the black plastic film to the side to locate the RAM slots.

    • Locate the metal clips holding the RAM card in place.

    • Using your fingers, push the metal clips out and away from the RAM module until the RAM module pops up at a 45 degree angle.

  7. Hold the black plastic film away from the RAM slots. Grasp the edge of the RAM card and slide it out at a 45 degree angle.
    • Hold the black plastic film away from the RAM slots. Grasp the edge of the RAM card and slide it out at a 45 degree angle.

    • Maintain the 45 degree angle of the RAM card until all pins are disengaged. Failure to do so may result in pin breakage.

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

Conor Most

회원 가입일: 2014년 04월 14일

2,329 평판

안내서 6개 작성하였습니다

Cal Poly, Team 3-40, Maness Spring 2014 Cal Poly, Team 3-40, Maness Spring 2014 회원

CPSU-MANESS-S14S3G40

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 11

지난 30일: 30

전체 시간: 1,604