기기를 수리하세요 커뮤니티 상점

HTC Flyer MicroUSB Port Replacement

필요한 것

  1. HTC Flyer MicroUSB Port Replacement, Back Cover: 1 단계, 이미지 1/3 HTC Flyer MicroUSB Port Replacement, Back Cover: 1 단계, 이미지 2/3 HTC Flyer MicroUSB Port Replacement, Back Cover: 1 단계, 이미지 3/3

    • Apply pressure along the bottom of the white panel containing the camera and push upwards.

    • It may take some effort, but it will smoothly slide off.

    번역하기

  2. HTC Flyer MicroUSB Port Replacement: 2 단계, 이미지 1/3 HTC Flyer MicroUSB Port Replacement: 2 단계, 이미지 2/3 HTC Flyer MicroUSB Port Replacement: 2 단계, 이미지 3/3

    • Unscrew the four of 3.5mm Torx T5 screws that run along the sides of the exposed innards.

    • All screws in the device will use the Torx T5 screwdriver, so keep it handy.

    번역하기

  3. HTC Flyer MicroUSB Port Replacement: 3 단계, 이미지 1/3 HTC Flyer MicroUSB Port Replacement: 3 단계, 이미지 2/3 HTC Flyer MicroUSB Port Replacement: 3 단계, 이미지 3/3

    • Remove the black protective piece of plastic by sliding it upwards.

    • Remove the two 3.5mm Torx #5 screws holding the protective plastic down on along the sides.

    • A center 3.5mm Torx screw will be covered by "VOID" sticker.

    • Either remove the sticker or jam the screwdriver into the screw, and remove the screw.

    • Remove the protective panel by sliding it upwards.

    번역하기

  4. HTC Flyer MicroUSB Port Replacement: 4 단계, 이미지 1/2 HTC Flyer MicroUSB Port Replacement: 4 단계, 이미지 2/2

    • Before removing the back cover, apply some scotch tape to the volume buttons to prevent them from falling out of the back panel.

    • Use a plastic opening tool to lever up the top half of the cover.

    • Lift the back panel up and remove it from the device.

    번역하기

  6. HTC Flyer MicroUSB Port Replacement, Battery: 5 단계, 이미지 1/2 HTC Flyer MicroUSB Port Replacement, Battery: 5 단계, 이미지 2/2

    • Gently unfold the black tape along the top that covers the cable attachment points.

    • Leave the tape partially attached so that it can be easily re-attached.

    번역하기

  7. HTC Flyer MicroUSB Port Replacement: 6 단계, 이미지 1/3 HTC Flyer MicroUSB Port Replacement: 6 단계, 이미지 2/3 HTC Flyer MicroUSB Port Replacement: 6 단계, 이미지 3/3

    • Use the tip of a spudger as a lever to disconnect the four cable connectors.

    • Gently pull out these cables after releasing the back piece.

    번역하기

  8. HTC Flyer MicroUSB Port Replacement: 7 단계, 이미지 1/1

    • Remove the single 2.5mm Torx T5 screw holding the battery down along the top side.

    번역하기

  9. HTC Flyer MicroUSB Port Replacement: 8 단계, 이미지 1/3 HTC Flyer MicroUSB Port Replacement: 8 단계, 이미지 2/3 HTC Flyer MicroUSB Port Replacement: 8 단계, 이미지 3/3

    • Wedge the flat end of a spudger inbetween the battery and the front panel assembly.

    • Run the flat end of a spudger along the top edge of the battery to separate it from the adhesive securing it to the front panel assembly.

    • If you encounter any resistance from the remaining adhesive, simply use the flat end of a spudger to remove the excess adhesive.

    번역하기

  10. HTC Flyer MicroUSB Port Replacement, MicroUSB Port: 9 단계, 이미지 1/1

    • Use a spudger to unclip the the wires attached to the power jack

    • The clips have a white or black relief tab that, when pressed, releases the wires.

    번역하기

  11. HTC Flyer MicroUSB Port Replacement: 10 단계, 이미지 1/2 HTC Flyer MicroUSB Port Replacement: 10 단계, 이미지 2/2

    • Remove the two 2.5mm Torx T5 screws from both sides of the power jack panel.

    번역하기

  12. HTC Flyer MicroUSB Port Replacement: 11 단계, 이미지 1/2 HTC Flyer MicroUSB Port Replacement: 11 단계, 이미지 2/2

    • Gently remove the power jack panel.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 3명과 함께

Joshua

회원 가입일: 10/07/14

185 평판

안내서 1개 작성함

배지: 5

배지 +2개 더

팀

USF Tampa, Team 8-5, Leahy Fall 2014 USF Tampa, Team 8-5, Leahy Fall 2014 회원

USFT-LEAHY-F14S8G5

3 회원들

안내서 12개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 1,167