필요한 것
-
-
Apply pressure and slide upward to remove back cover.
-
Lift the back cover up away from the phone.
-
-
-
Using a T5 screwdriver, remove the four screws in corners as shown.
-
Lift the top portion of the rear case.
-
-
-
-
Using an IfixIt Plastic Tool, detach the plastic casing from the keyboard. This may require some force.
-
Using a spudger or other thin tool, carefully pry up ZIF connectors as shown. This will allow the black ribbons to detach from the keyboard.
-
Slide the two parts away from each other so that the black ribbons slide through the slots and you will now have housing into two parts.
-
-
-
Peel the off yellow ribbon slowly.
-
Unscrew the fours screws in red squares (two in each square) using a 00 screwdriver.
-
After the screws are out you will be able to easily take off the small metal pieces.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 5명이 해당 안내서를 완성하였습니다.
팀
Cal Poly, Team 9-64, Walters Spring 2011 Cal Poly, Team 9-64, Walters Spring 2011 회원
CPSU-WALTERS-S11S9G64
5 회원들
안내서 18개 작성하였습니다
