주요 콘텐츠로 건너뛰기

소개

If your Monster DNA headphones are playing noise out of only one side then it is likely that there is a loose wire and this will need to be soldered. This happens frequently because small tensions on the wire can loosen the solder joints easily. To do so, you must disassemble the earpiece and reattach the wires.

  1. Take off the ear cushions by pulling on the sides.
    • Take off the ear cushions by pulling on the sides.

  2. Use a Phillips #2 screwdriver to unscrew the three 5mm screws that secure the speaker cover.
    • Use a Phillips #2 screwdriver to unscrew the three 5mm screws that secure the speaker cover.

  3. Use a plastic opening tool or a metal spudger to pry off the plate
    • Use a plastic opening tool or a metal spudger to pry off the plate

    • Be careful as too much force may cause damage to your headphones.

  4. Once the loose wire or wires are located on the back of the speaker,  use a soldering iron to attach the loose wire back onto the speaker.
    • Once the loose wire or wires are located on the back of the speaker, use a soldering iron to attach the loose wire back onto the speaker.

결론

To reassemble your device, follow these instructions in reverse order.

Kevin Costello

회원 가입일: 2017년 03월 22일

213 평판

안내서 2개 작성하였습니다

UMass Dartmouth, Team S4-G5, Julie Spring 2017 UMass Dartmouth, Team S4-G5, Julie Spring 2017 회원

UMASSD-JULIE-S17S4G5

4 회원들

안내서 3개 작성하였습니다

any ways on being able to know which side its on in particular without having to open both sides?

Finnlay Worchurst - 답글

댓글 쓰기

조회 통계:

24 시간 전: 4

7일 전: 10

30일 전: 47

전체 시간: 1,984