주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

소개

Step-by-step guide to replacing the keypad sensor.

부품

지정된 부품이 없습니다.

  1. Flip the phone over so the back cover is facing up. Using either a finger or a spudger, press the button located near the top of the phone by the antenna.
    • Flip the phone over so the back cover is facing up.

    • Using either a finger or a spudger, press the button located near the top of the phone by the antenna.

  2. Pry up the back plate from the phone. Push the button near the bottom of the battery using either your finger or the spudger to release the battery.
    • Pry up the back plate from the phone.

    • Push the button near the bottom of the battery using either your finger or the spudger to release the battery.

  3. Using a T6 Torx screwdriver, remove the four screws from the back of the phone.
    • Using a T6 Torx screwdriver, remove the four screws from the back of the phone.

  4. OPEN ALL THE TABS

    RAM Upgrade Kits for Mac

    키트 쇼핑하기

    Enough RAM
    For All The Tabs

    키트 쇼핑하기
  5. Simultaneously press the highlighted buttons on both sides of phone. Simultaneously press the highlighted buttons on both sides of phone.
    • Simultaneously press the highlighted buttons on both sides of phone.

  6. Separate the back plate from the rest of phone.
    • Separate the back plate from the rest of phone.

    • Do not pull the wire connecting the front and back plates.

  7. Gently lift logic board from back plate.
    • Gently lift logic board from back plate.

  8. Place logic board on front cover. Unsnap orange wire that connects the logic board to keypad sensor to allow the logic board to move freely.
    • Place logic board on front cover.

    • Unsnap orange wire that connects the logic board to keypad sensor to allow the logic board to move freely.

  9. Once logic board is removed lift the green keypad sensor for the front plate. Once logic board is removed lift the green keypad sensor for the front plate.
    • Once logic board is removed lift the green keypad sensor for the front plate.

결론

To reassemble your device, follow these instructions in reverse order.

Elizabeth OBrien

회원 가입일: 2010년 04월 26일

43 평판

안내서 7개 작성하였습니다

Cal Poly, Team 30-40, Garner Spring 2010 Cal Poly, Team 30-40, Garner Spring 2010 회원

CPSU-GARNER-S10S30G40

4 회원들

안내서 14개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 1,866