주요 콘텐츠로 건너뛰기

소개

These instructions are for an original Nintendo Wii remote, model number RVL-003, also called Wiimote. Nintendo Wii Remote users who have problems controlling the movement of the controller and/or connecting to the sensor bar can fix the issue by replacing the sensor screen within the remote.

Users should first look for dust blocking the LED lens or inspect the remote for other signs of corrosion or deterioration, check the battery, recalibrate the remote, and make sure the sensor bar is connected and not being blocked. If all checks out, it is possible that the sensor screen may need to be replaced.

Inside the Wii remote are built in optics that mimic a camera that connects to the sensor bar’s infrared LED. In addition, the remote contains a silicone anchor that controls the movement of tiny chips that are called accelerometers. Moving the remote up, down, and side to side move the accelerometers inside, which result in movement on the game screen. The remote also contains a stable Bluetooth chip that communicates with the console.

Replacing the sensor requires the user the obtain a new sensor screen part. Wii remote parts may be found on eBay.

  1. Flip the Wii Remote over so the battery cover faces you. Push up on the bottom tab.
    • Flip the Wii Remote over so the battery cover faces you.

    • Push up on the bottom tab.

    • Remove the battery cover.

  2. Remove the first battery by pressing down on the positive end and pulling the battery out.
    • Remove the first battery by pressing down on the positive end and pulling the battery out.

    • Remove the second battery by pushing up on the positive end and pulling the battery out.

  3. Using a tri-point Y1 Screwdriver, remove the two center 7mm screws by turning them counterclockwise.
    • Using a tri-point Y1 Screwdriver, remove the two center 7mm screws by turning them counterclockwise.

    • Repeat with the two bottom screws.

  4. With the flat end of a spudger, gently apply pressure to the tabs located on left side of the controller. These tabs are breakable. However, if the tabs are broken the controller will still function.
    • With the flat end of a spudger, gently apply pressure to the tabs located on left side of the controller.

    • These tabs are breakable. However, if the tabs are broken the controller will still function.

    • Open the front plate like a book.

    • Small parts may fall out as you open the front plate.

  5. Tilt the remote, without the front cover plate, upward so the handle strap is at the bottom and the black screen is facing you. Grip the outward edge of the screen with your fingers. Gently, pull the screen straight outward from its housing. The screen will slide directly out.
    • Tilt the remote, without the front cover plate, upward so the handle strap is at the bottom and the black screen is facing you.

    • Grip the outward edge of the screen with your fingers.

    • Gently, pull the screen straight outward from its housing. The screen will slide directly out.

결론

To reassemble your device, follow these instructions in reverse order.

다른 7명이 해당 안내서를 완성하였습니다.

Emily

회원 가입일: 2013년 04월 14일

945 평판

안내서 6개 작성하였습니다

Cal Poly, Team 3-44, Amido Spring 2013 Cal Poly, Team 3-44, Amido Spring 2013 회원

CPSU-AMIDO-S13S3G44

4 회원들

안내서 18개 작성하였습니다

댓글 한 개

Where can the screen be purchased??

cutsiepie6480 - 답글

댓글 쓰기

조회 통계:

24 시간 전: 4

7일 전: 29

30일 전: 129

전체 시간: 12,455