주요 콘텐츠로 건너뛰기

Palm Centro Speakers Replacement

필요한 것

  1. Palm Centro Speakers Replacement, Disassembling Palm Centro Battery: 1 단계, 이미지 1/2 Palm Centro Speakers Replacement, Disassembling Palm Centro Battery: 1 단계, 이미지 2/2
    • Press and slide open the battery cover.

  2. Palm Centro Speakers Replacement: 2 단계, 이미지 1/1
    • Caution: Turn cell phone off before removing battery!

    • Press battery to the right.

    • Then lift up battery pack to remove.

  3. Palm Centro Speakers Replacement: 3 단계, 이미지 1/1
    • Phone with battery removed

  4. Palm Centro Speakers Replacement, Back Housing: 4 단계, 이미지 1/1
    • Remove the touchpad pen from the top left corner on the back to reveal the last of 6 screws to be removed.

  5. Palm Centro Speakers Replacement: 5 단계, 이미지 1/1
    • Lift the rubber cap at the top right to reveal the sixth screw.

    • Caution: There is a small Palm sticker under the rubber cap. Tampering with or removing this sticker will void your warranty!

    • Remove the six screws using the T5 Torx screwdriver.

  6. Palm Centro Speakers Replacement: 6 단계, 이미지 1/2 Palm Centro Speakers Replacement: 6 단계, 이미지 2/2
    • Remove the SIM card so housing can be separated.

  7. Palm Centro Speakers Replacement: 7 단계, 이미지 1/2 Palm Centro Speakers Replacement: 7 단계, 이미지 2/2
    • Use a plastic pry tool to separate the bottom of the case to remove the small plastic insert.

  8. Palm Centro Speakers Replacement: 8 단계, 이미지 1/2 Palm Centro Speakers Replacement: 8 단계, 이미지 2/2
    • Remove the small plastic insert at the bottom of the phone.

  9. Palm Centro Speakers Replacement: 9 단계, 이미지 1/2 Palm Centro Speakers Replacement: 9 단계, 이미지 2/2
    • Continue with plastic pry tool all the way around the phone to remove the back housing.

  10. Palm Centro Speakers Replacement, Logic Board: 10 단계, 이미지 1/1
    • Carefully peel back the tape holding the speaker (left) and keyboard (right) connection tabs in place.

  11. Palm Centro Speakers Replacement: 11 단계, 이미지 1/1
    • Using the plastic prying tool, lift the tabs and carefully pull the contact connections out on both sides.

    • Be very careful, these electronics are delicate!

  12. Palm Centro Speakers Replacement: 12 단계, 이미지 1/1
    • Separate the logic board from the case by lifting and pulling out the bottom.

  13. Palm Centro Speakers Replacement, Speakers: 13 단계, 이미지 1/3 Palm Centro Speakers Replacement, Speakers: 13 단계, 이미지 2/3 Palm Centro Speakers Replacement, Speakers: 13 단계, 이미지 3/3
    • Pry the four plastic latches free that connect the antenna to the logic board.

    • Excessive force may damage your logic board!

    • Remove the antenna from the logic board.

  14. Palm Centro Speakers Replacement: 14 단계, 이미지 1/1
    • The internal speaker is attached to the antenna. To remove it, pry the speaker from the antenna using the tip of your screwdriver.

    • The speaker should be placed back into its spot in the correct position. Take notice of the gold connectors

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Kevin

회원 가입일: 04/12/10

31 평판

안내서 1개 작성함

Cal Poly, Team 15-49, Garner Spring 2010 Cal Poly, Team 15-49, Garner Spring 2010 회원

CPSU-GARNER-S10S15G49

5 회원들

안내서 12개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 1,470