Protocol Dronium Two Blade Guard Replacement - iFixit 수리 안내서

소개

This guide shows how to remove the blade guard on the Protocol Dronium Two. The only tool you will need is the #0 Phillips screwdriver. The screwdriver is also included in the box of your drone. Perform this repair in a clean and well lit area so that you don't lose the screw.

필요한 것

1 단계 Blade Guard

Protocol Dronium Two Blade Guard Replacement, Blade Guard: 1 단계, 이미지 1/1

Turn the drone off by moving the selector switch to the left.

2 단계

Protocol Dronium Two Blade Guard Replacement: 2 단계, 이미지 1/2

Protocol Dronium Two Blade Guard Replacement: 2 단계, 이미지 2/2

Using your screwdriver, remove the 8.36mm Phillips screw.

3 단계

Protocol Dronium Two Blade Guard Replacement: 3 단계, 이미지 1/1

While holding the drone with one hand, gently lift the blade guard straight up and remove it.
Be careful not to break off the two studs holding the blade guard in place.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 2명과 함께

Edwin Brietz

회원 가입일: 01/18/17

530 평판

안내서 4개 작성하였습니다

배지 +6개 더

팀

Arkansas State University, Team 1-2, Chamberlain Spring 2017 Arkansas State University, Team 1-2, Chamberlain Spring 2017 회원

ARSU-CHAMBERLAIN-S17S1G2

4 회원들

안내서 5개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 2

전체 시간: 203