소개

In order to remove the inner components, you must first remove the keyboard. The keyboard can also be replaced.

부품

부품은 필요하지 않습니다.

  1. Position the laptop screen-side down as shown.
    • Position the laptop screen-side down as shown.

    • In this position the battery housing will be located on the right hand side.

    댓글 쓰기

  2. Lift the panel up and then out to gain access to the battery.
    • Lift the panel up and then out to gain access to the battery.

    댓글 쓰기

    • Use the indentations to pull the old battery out.

    댓글 쓰기

    • The battery is now removed and it is safe to move on to uninstalling other components.

    댓글 쓰기

    • There are two screws on the left hand side of the laptop near the IR (Infared remote) receiver (see image). Remove them using a Phillips #00 Screwdriver.

    • Slide the speaker panel towards the left, then carefully flip it over onto the keyboard.

    • Make sure not to pull the speaker panel away from the computer just yet - it is still connected!

    댓글 쓰기

    • On the inside of the speaker panel, using a spudger, push the beige tab in the direction of the ribbon. It should only move a small amount.

    • Remove the ribbon by gently pulling on it, there should be little or no resistance.

    • Now the speaker panel can be set aside.

    댓글 쓰기

    • Remove the metal screw that will be located at the red circle.

    • Pull on the green strip, and the keyboard should come free easily.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

ahintz

회원 가입일: 2010년 04월 21일

19 평판

안내서 8개 작성하였습니다

Cal Poly, Team 16-3, Maness Spring 2010 Cal Poly, Team 16-3, Maness Spring 2010 회원

CPSU-MANESS-S10S16G3

3 회원들

안내서 8개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 1,239