Electronics is my career and hobby!
I am and Electrical Engineer by trade. Decided to study my M.S. in Biomedical Engineering which I recently completed. Now pursuing my PhD for fun.
How did I get into the repair business?
One of my friends broke her iPhone and decided to give it a shot. I loved the experience and kept doing it on the side while going to school. I asked her to keep the screens that came in the toolkit instead of money... haha
A few months later I opened my first shop in Memphis, TN and it has been a very fun experience. This was in 2012 so I have been in the industry for a little while now. I am very experienced with refurbishing and micro soldering, so feel free to reach out if you have any questions!
STS Repair has recently opened its Board Repair Services (Mail-ins).
You are welcome to check out our website at www.stsrepair.com!
You can contact me at email@example.com
내가 작업한 분해도
사용자에게 답변하기: How to put a screw hole back after long screw damageYou can solder it back on. Just place it and sit your soldering iron on top of the socket, it will heat enough to solder itself back on.
사용자에게 답변하기: Broke the lightning connector - parts stuck in logicboardIt seems like corrosion made those connectors stick. You have to replace that connector and inspect around logic board to make sure there is no more damage on the logic board. If you are not a micro solderer id recommend finding a shop who can help!
사용자에게 답변하기: Side Clips Not Holding on Replacement ScreenStart by the top clips on the screen. Make sure they go into the frame. Then you do the sides and make sure they go in. If they are not easily going in and the frame is not bent you can help sliding a knife looking tool to help those clips to slide into place. Lastly, do the bottom. Triple check for bent frame, otherwise you will be breaking that screen!
사용자에게 답변하기: Need Replacement Coax Wifi Connector - Any place to buy?Sometimes if you cant find in a marketplace you can buy a "dead" motherboard. I usually keep some to be donor boards.
사용자에게 답변하기: How much does a new screen costIt depends where you buy, however I'd say around $150 for the part.
사용자에게 답변하기: Why is this happening?Have you tried reset all settings?
사용자에게 답변하기: White lines on screenJack, This could have happened due to the phone being dropped as well. If no repairs were performed a drop could cause the flex cables to lose contact with the LCD contact glass causing the glitch you describe. You have to replace the screen in this case for a successful repair!
사용자에게 답변하기: New battery doesn't workIt seems like you might have received a faulty battery. I would try another one!!
사용자에게 답변하기: Charge port not workingYou would be looking at the Tristar IC. Let me know if you need help!
사용자에게 답변하기: iPhone is on but no screenHey there! haha Thanks Mayer, we all learn things everyday. Savas, you can either have a no backlight issue or a not image issue. It sounds like no backlight is the issue even though you say shining a light doesn't help. It is hard sometimes to see image, usually when you are turning on the phone and the apple logo is shown the best time to identify backlight issue. If it is a non image issue most likely there are small square components on top of the LCD connector that could be knocked off easily. However backlight circuit can be affected when working on a phone with a plugged battery, so make sure to ALWAYS disconnect the battery first! I can look at it if you want to mail it in ;)
15 페이지 중 페이지 1