Eigirdas Gedgaudas

Hi there, ive got into quite awkward situation here. Got iPhone 7 for repair and had to change Docking Flex connector as ligh...

Beats solo 3 hinge separates by propping of top plastic following carefully by the edges . There is no glue or screws holding covers up.

Agree with @ samy , as well before applying new strip, clean frame with ipa to remove any skin oils or adhesive leftovers. After applying strips and sticking screen on , add some books all over the ipad and leave it for at least several hrs in room temp. Adhesive strips needs some time to make a good bond

Jaybird x3 has batteries located in your earpieces. When u solder it be careful ir “B” contacts .

Ive done it using heat and OEM button. First attempt to use glass only from ebay was unsuccessful. Touch didint worked. So ive used spare button as a donnor . And regarding adhesive- UV curable same as you wold be using for digitiser only repair

Could you be more specific please? Is it still usable? If battery is empty and u put on charge and then starts blinking it could be a sign of weak battery or poor connection of you charging port/lightning cable.

Sounds like board repair required. Most likely charging ic requires attention…

Hi there, i asume it could be because of MHz of your rams. Check motherboard/computers manual, it should tell you supported tipes of rams

Backlight replacement required

Charger is too weak. Not enough amp

Have a try usb mouse. Ither way. It IS A DRIVER ISSUE

Its a cap not a battery :D