"replace 6' hose on bottom of rotator head"에 답변Replacing embedded hose in power unit on Shark model NV752 Update (02/22/2020): Replacing embedded hose in power unit on Shark model NV752
"The hose that goes from brush head to handle is needing replaced"에 답변You do not have to take apart the pivot section. Just follow the steps on this website for headlight replacement until step seven. make sure you have a t20 security bit driver. the rest is simple.
"Replacing embedded hose in power unit on Shark model NV752"에 답변I replaced this hose recently on mine. I was unable to find anywhere online a replacement hose that explicitely stated my exact model of vacuum. Here is what I bought from the Walmart website without knowing for sure if it would fit, as it was for different models of shark vacuum cleaners. Here is the description: “Lower Nozzle Hose for Shark Rotator Vacuum Cleaner NV341 NV501 UV560” I have the Shark Rotator Powered Lift-away NV755 (Best buy model). This hose worked perfectly. It’s important that the direction of the spiral is the same. If the spiral on this hose was the thread on a bolt, it would be a left-hand thread. I followed the very good directions on this website for headlight replacement to step 7 to locate all of the screws that needed to be removed. I would only add that on mine, one of the two screws circled in yellow located beneath the beater brush cover was a T20 torx security bit. not to be confuse with the smaller regular torx hidden under the gasket. I wasted time thinking I had to...