이 사용자는 아직 프로필을 작성하지 않았습니다.
내 경험담
질문
My Aeroccino stoped working. The last time I've tried to use it, when I press the button it do not react, the light...
더 읽어보기I replaced the battery of my iphone 5 following the instructions in this site, and everything seemed okay until the end....
더 읽어보기the loudspeaker volume of my iPad2 got very low and even if I adjust to the maximum, it is still low.
더 읽어보기I have cleaned my Mighty Mouse several times following your instructions manual, but the last time I did it, the ball...
더 읽어보기I got a Kingston 120GB SSD and I bought a Dual Drive Kit with all the tools and a cable to do the job. I was following the...
더 읽어보기The Trackpad of my MacBook 13" Late 2009 Model A1342 was slightly up in the left side, so I decided to open it to check...
더 읽어보기My Wi-Fi is not working. In which board the problem is located?
더 읽어보기I cannot turn my iPhone off. When I press and hold the power button, nothing happens. I even cannot reset it by holding...
더 읽어보기I have a Mac Mini late 2012 model A1347. It runs OK, but the only bottleneck is the 5200 rpm hard drive. Could I replace...
더 읽어보기I think my hard drive is failing because after a series of tests with Disk Utily and Apple Hardware Utility, I got errors....
더 읽어보기2 페이지 중 1
답변
The second image.
더 읽어보기The base of the Aerocino has 3 screws near the margin and another one in the center. I've tried to take photos of them, but it was difficult. The photos are attached to this message.[문서: Base 02][문서: Base 01]
더 읽어보기Checking the photo of a trackpad for the MacBook, I have noticed there's 2 mounting pads in the lower edge of it. And now I remember when I reached my trackpad, these 2 mounting pads were missing. I think this is the reason why it's not flush with the body of the MacBook. Regarding to the loose screws, when I open my MacBook again I'll double check to see if one of these screws are missing in the parts you mentioned in your answer. Thank you very much Jeff.
더 읽어보기안내서 댓글
Abou 2 years ago I have followed these instructions to clean my mouse and everything was perfect. But now I tried this procedure again, but the mouse ball isn't working anymore. I thought I had the flat cables in the wrong position, and then I checked it, and I think they are in the correct position. The photos are small and I cannot be sure the position of the flat cables are correct. I would like to know how can I check this. What is the correct side to insert these flat cables? I'm sure I close the ball box correctly and it's running smooth inside it.
sergio barrozo
@sergiobarrozo
41
평판
3
해결책
0
안내서
회원 가입일 01/18/12
투표
3
0