이 사용자는 아직 프로필을 작성하지 않았습니다.
질문
hi. i have an iphone x that is stuck on error 6 when trying to restore it. it had a small drop and was stuck on the apple...
더 읽어보기Hi. Just want to ask if NO SERVICE and SEARCHING on the iPhone 6 are the same fault? I have one that has no service. I did...
더 읽어보기Hi, have an iPhone 6 that had a dark patch on the top right hand side of the display. The phone worked ok. I checked the...
더 읽어보기hi, i have a 5c that wont charge a dead battery but will charge a battery that has power? i have change the charging chip...
더 읽어보기hi, i have a sharp 32" tv that wont turn on. when you press power button on remote, the stand by light flashes blue 7...
더 읽어보기hi. i have an iphone with a board fault. when using the keyboard the letters (y,g,h,b) dont work. i have tried a known...
더 읽어보기hi. i have a 5s with an issue with the small camera not working. the phone had water damage near the fpc. i have tested...
더 읽어보기Hi, I have a GeForce gtx780 video card that has a blown chip on it. There are two pairs of components I need to replace...
더 읽어보기hi, i have an iphone 5 with a black display. i have tried a new screen, battery and tried the board in another phone but...
더 읽어보기Hi, just wanted to know if I can upgrade the graphics card on Sony Vaio sve151d11m or add a graphics card externally?
더 읽어보기2 페이지 중 1
답변
have you tried using something like a needle to pry it back out? if that doesnt work you will need to remove the screen to access the buttons. you should watch a few youtube videos first to see if its something you want to try
더 읽어보기have you checked at the back of the sim tray for any damaged components?
더 읽어보기check to see if the storage memory is full.
더 읽어보기i use oca adhesive sheets for all screen replacements. you need to cut it into strips to size but so far its the best solution i have found as it never lifts afterwards. its a bit tricky to work with but its worth the trouble. it bonds the digitizer to the frame very well and is thin enough so as not to leave the screen standing proud of the frame. i have also used b700 glue for frames with very thin edges to bond too. the oca is hard to work with when it needs to be cut very thin.
더 읽어보기hope the schematics helped. did you know that the power/camera board can be got on its own. they can be found on ebay and are straight forward to replace. would save a lot of messing about. just make sure its the right one as i think there are two types.
더 읽어보기the wifi antenna is held in place with adhesive and one screw. easy enough to remove. you do need to remove the vibrator as well because it shares a screw with the antenna.
더 읽어보기when you enter it wrong it sould give you the option to reset by email. check the screen for an icon to reset
더 읽어보기download itools english version. its a very user friendly program for idevices.
더 읽어보기if its heating up then it could possibly have a short near the power ic. test for one with
더 읽어보기you can get them on ebay
더 읽어보기5 페이지 중 1
trevor
@corklad
973
평판
45
해결책
0
안내서
회원 가입일 04/12/13
투표
12
1