이 사용자는 아직 프로필을 작성하지 않았습니다.
질문
I have a Water Damaged iPhone 5s that I'm working on which cannot detect the SIM card. The phone has been properly cleaned...
더 읽어보기I'm working on a 5 s which took a few knocks and needs the screen replaced. Another problem was that the user couldn't...
더 읽어보기So I have an iPad 2 and an iPad mini which seem to have similar problems. Both are recognized by iTunes as being in...
더 읽어보기I have an iPad 2 64GB GSM model that works fine in every aspect except the following: When the ipad is put to sleep or...
더 읽어보기I have an iPad 2 w/ 3G that has a consistently accurate GPS. It always seems to be off by a 1/2 mile or so.THis occurs...
더 읽어보기I have a first Gen ipad mini that got run over by a couple cars after falling out of an open trunk. The chassis , LCD and...
더 읽어보기My Wife's iPhone 4 up and quit a few weeks ago. No signs of life on the charger or in iTunes. The dock connector was...
더 읽어보기I have an iPad 1st Gen 64 GB/ 3G that was water damaged. The previous owner tried to disassemble and broke the digitizer...
더 읽어보기I have an iPad 3 that was missing the digitizer and the LCD was trashed when I got it. Tried charging it and connecting to...
더 읽어보기I have a cannon mg52oo printer that was printing fine one moment then it just started spitting out blank pages. The print...
더 읽어보기2 페이지 중 1
답변
Compare it to your background picture . It could be a faded image in the background,
더 읽어보기If you have a 6th Generation Touch with a bad battery, you may want to consider returning it for warranty as they have only been on the market for less than 6 months.
더 읽어보기Did you try a hard reset? Hold power and home button at the same time for 10 seconds.
더 읽어보기If you don't feel confident in doing the repair then take it to a reputable shop and have them do it for you. The iPad mini is not for the feint of heart when if comes to screen replacement. From backlight issues to phantom touch, there are many things that can go wrong if you aren't careful. If you are interested in device repair, have a knack at it and not too concerned about things going sideways or are willing to soldier on when they do, then have at 'er.
더 읽어보기I have an iPad 2 here that will boot up , the apple logo comes on, then disppears. About a minute later the home screen will appear and it functions as normal. Is it possible that you may need to wait a minute or so after booting the customers iPad?
더 읽어보기You may want to have a close up inspection of the Digitizer connector on the logic board to make sure it isn't cracked or missing a pin.
더 읽어보기It's likely that the iPad will need to have the lcd cable reconnected. Sometimes smacking the back doesn't work. With the proper instructions And patience you can open the iPad and do this. Be sure to power the iPad off first though. Just hold the power button for about 5-10 seconds then swipe not the screen towards the top where slide to turn off would be. You should see the backlight dim slightly then turn off. Follow the ifixit guide to open an iPad 2, and you'll be good to go.
더 읽어보기If you are referring to the 16 gb 5 th generation that was released without a rear camera, then no you can't add a rear camera. There is no spot on the logic board to plug it in.
더 읽어보기Should be pretty straight forward. Typically the screws are on the front holding both the grill and driver in place. There might be some gasket or adhesive holding the speaker in place.
더 읽어보기If you didn't power off the iPad when working on it , it is likely that you blew the lcd backlight filters when you plugged or unplugged the lcd. This will require a board level repair.
더 읽어보기29 페이지 중 1
안내서 댓글
I'm going to guess that the Air 1 digi won't fit due to the touch ID button being bigger than the regular home button.
투표
61
5