내가 기여한 안내서
완성된 안내서
내 경험담
MBP HD Cable
MacBook Pro 13" Unibody Mid 2012 Hard Drive Cable
Swap out iMac PS
iMac Intel 21.5" EMC 2308 Power Supply
Be brave; you can do it!
iMac Intel 21.5" EMC 2544 Hard Drive
취소
MacBook Pro 13" Unibody Mid 2012 Hard Drive Cable
iMac Intel 21.5" EMC 2308 Power Supply
iMac Intel 21.5" EMC 2544 Hard Drive
지난 90 일 동안 귀하께서 활동한 시간대 입니다. 이 그래프의 각 행은 귀하께서 사이트에서 수행한 작업을 나타냅니다 (투표 및 게시물 편집과 같은 주요 활동만 집계합니다). 도표 하단의 숫자는 산악 표준 시간 입니다.
이벤트 | 개수 | 델타 |
---|---|---|
게시물이 추천되었습니다 | 19 | 228 |
승인된 답변 | 3 | 30 |
답변 승인함 | 1 | 30 |
게시물을 비추천하였습니다 | 1 | -2 |
게시물이 비추천되었습니다 | 1 | -6 |
I absolutely “ditto” this! I simply removed the upper 2 screws securing the logic board and carefully wedged something underneath its edge to make a bit more room. I, too, was able to remove and replace RAM by removing only those screws and the fan. Getting the RAM out is fairly easy. Replacing the module closet to the board—-the first one—-is really easy. It’s the 2nd module that will try your patience. My fingers are blunt and “fat, so I actually taped the RAM chip to my fingertip and then used a bent wire (not bare metal wire) to maneuver the chip into its slot. To do all that took less time and anxiety than removing all required with the full-step operation.
Please be aware that you CAN do this replacement with MUCH LESS work. I successfully replaced a trackpad (TP) in this model WITHOUT removing a lot of what is described here. I think i mainly removed the logic board (LB) anchor screws along the TP side and was then able to lever up the LB just enough to get the cable unplugged and snaked out. Followed the reverse and done. Maybe not for all, but it worked for me. // Re screws: i print out the images here of the multi-screws locations and then tape the screws in place on the print-out
Please be aware that you CAN do this replacement with MUCH LESS work. I successfully replaced a trackpad (TP) in this model WITHOUT removing a lot of what is described here. I think i mainly removed the logic board (LB) anchor screws along the TP side and was then able to lever up the LB just enough to get the cable unplugged and snaked out. Followed the reverse and done. Maybe not for all, but it worked for me. // Re screws: i print out the images here of the multi-screws locations and then tape the screws in place on the print-out.
Mine has these cables exactly opposite what is shown here. (?)
Step #16 is kinda confusing on the last paragraph. Can anyone clarify.? Thanks.