시간당 평판
평판 내역
이벤트 | 개수 | 델타 |
---|---|---|
누군가 귀하의 안내서를 좋아요 하였습니다 | 730 | 6250 |
누군가 귀하의 안내서를 완성하였습니다 | 547 | 4829 |
게시물이 추천되었습니다 | 42 | 504 |
관리자가 귀하의 안내서를 승인하였습니다 | 4 | 400 |
귀하의 안내서 링크를 포함한 추천 게시물 | 19 | 172 |
답변 승인함 | 2 | 60 |
승인된 답변 | 5 | 50 |
이벤트 | 개수 | 델타 |
---|---|---|
누군가 귀하의 안내서를 좋아요 하였습니다 | 730 | 6250 |
누군가 귀하의 안내서를 완성하였습니다 | 547 | 4829 |
게시물이 추천되었습니다 | 42 | 504 |
관리자가 귀하의 안내서를 승인하였습니다 | 4 | 400 |
귀하의 안내서 링크를 포함한 추천 게시물 | 19 | 172 |
답변 승인함 | 2 | 60 |
승인된 답변 | 5 | 50 |
Please check that the connecting wires were insulated correctly and that they are not touching anything internally. That might be a hazard. If it heats up so much I would not use it.
I have come across many chargers now. Some open the way you said, some are a pain to open. I believe it varies with the year they were manufactured because some have way more glue than others and have a different setup of the circuit board. I now use a hot air gun to soften the internal adhesive, will update the guide later.
Thanks for your comment!
It is, I have repaired chargers by resoldering the wires onto the circuit board. Just make sure that both wires are well isolated from each other.
LOL haven't checked this guide in months xD
Done! Check your inbox :)
Hi victor, the model and name parts with the link of where to purchase are listed above ^__^
Sennheiser 072512
Power Switch For SK100G2/SK300G2
I put a small piece of 2mm double sided tape on one corner. The soldering that was there was minimal, just to keep it in place from the looks of it. It has not given me any problems and have now been using it for more than a year!
Hi! thanks for sharing! I used that guide on another AC charger and was so much easier to take apart!
Here you can also apply heat and it will come out very easy. Great guide!
Here is the original comment by Dan:
Ive replaced a few of these screens with new glass and the double sided tape. Only issue that has always happed is that the glass will touch the digitizer in the middle once in awhile. This registers a touch that is stuck on and locks up the rest of the touch screen. The only work around is pressing on the glass around the outside of the lcd to release the unwanted touch. Tonight I discovered a great method for curing that problem. I removed the glass and cleaned up very well. Then applied a cut down screen protector for a LG spectrum to underside of the glass to bridge the gap between the glass and the digitzer. Retaped and assembled. This has worked perfect to correct and the screen looks great! Make sure to buy a screen protector that is clear. A protector that is anti-glare would dim the display. With the clear you cant tell its there. Very happy with the results!! Dan
4페이지 중 1페이지
다음