@ddugan the 4 times blink error is usually a Temp or a Fan error. For probable causes you need to check
- Fan1-4 Power is not supplied. (GI board)
- Fan connector is not seated securely.
- Fan caught wires or harnesses.
- Internal temperature is too high.
-
- IIC-E line connector(H4 board) is not seated properly.
+
- IIC-E line connector(H4 board) is not seated properly.
+
+
Try to see if you can get into the Self Diagnosis Screen. Unplug your set for a few minutes. Plug it back in. In standby mode, press the buttons on the Remote Commander sequentially, '''in rapid succession''' as shown below:
@ddugan the 4 times blink error is usually a Temp or a Fan error. For probable causes you need to check
- Fan1-4 Power is not supplied. (GI board)
- Fan connector is not seated securely.
- Fan caught wires or harnesses.
- No picture/No sound
- Internal temperature is too high.
- IIC-E line connector(H4 board) is not seated properly.