Phone restarts at random.

Question

iPhone 6 Plus

2014년 9월 19일에 출시된 이 5.5” 스크린 iPhone은 iPhone 6의 큰 버전입니다.

1525 질문 전체 보기

Brent Norris @b23norris

평판: 571

Brents Computer Repair

6

10

게시일: 2018년 6월 10일

옵션

Phone restarts at random.

Phone started restarting at random. Battery shows 1% then after plugging it in it will jump to around 48% unplug it and it drops down to 1%. I replaced the battery, yet still have the same problem restarting and battery not showing correct percent. I replaced the charging port and still have same issue. Phone now will only restart when I try to use it. If it is sitting and not being used then it will not restart. I have done a factory reset on it also. Any ideas what else could be wrong?

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 0

댓글 달기

답변 2개

선택된 답변

Minho @refectio

평판: 221.4k

15

289

807

게시일: 2018년 6월 11일

옵션

Hmmm...I will say that those are symptoms of a bad battery. It is possible that your replacement battery is also defective. Have you tried measuring the voltage directly at the battery connector with a multimeter - if so, what voltage are you reading? Ideally, you would want to confirm that your replacement battery works in another phone or install a known-good battery in the phone that is being repaired.

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 3개:

Volt check at 3.59 V So I don't think its the battery.

Brent Norris 의 2018년 6월 11일

Well, it's not quite that simple :>). Voltage is one thing, ability to drive current is another. The voltage can look fine but what happens to the voltage when you have a high current demand? I did some tests recently on iPad batteries using a electronic dummy load. When the current demand is high, the battery voltage drops down a lot, well below what is needed to boot a device. A weak or defective battery would have the same symptoms yet still show 4.2V when fully charged. It's just that it can't maintain any current drive without dropping the voltage.

So yes, your battery may be fine but don't use just voltage to determine the health. Ideally, you need to eliminate a variable. Use a known-good battery or install the current one in a known-good housing. That's when you can rule it it completely.

Minho 의 2018년 6월 11일

Is there any way to test this?

Brent Norris 의 2018년 6월 12일

댓글 달기

Well, it's not quite that simple :>). Voltage is one thing, ability to drive current is another. The voltage can look fine but what happens to the voltage when you have a high current demand? I did some tests recently on iPad batteries using a electronic dummy load. When the current demand is high, the battery voltage drops down a lot, well below what is needed to boot a device. A weak or defective battery would have the same symptoms yet still show 4.2V when fully charged. It's just that it can't maintain any current drive without dropping the voltage.

So yes, your battery may be fine but don't use just voltage to determine the health. Ideally, you need to eliminate a variable. Use a known-good battery or install the current one in a known-good housing. That's when you can rule it it completely. — Minho

Michael T @mthomas12941 평판: 1 3 · Answer 1 · 2018-06-12T17:06:57-07:00

Michael T @mthomas12941

평판: 1

3

게시일: 2018년 6월 12일

옵션

I'd probably say that it's a bad connector. Plug everything in, let it turn on and then tap it against a surface in a couple different angles. If it turns off when you hit the phone against a surface then it's just a bad connection somewhere on the battery or phone

해당 답변은 도움이 되었습니까?

예 아니요

점수 0

댓글 달기

iPhone 6 Plus

Phone restarts at random.

답변 2개

귀하의 답변을 추가하세요