옵션

My Washer fills then does wash cycle , drains but does not fill again.

I only have one water source cold water. The first indication of trouble was it would not fill up with water. So I checked the filter screens, which were clean then I changed the water connection to the hot water input and selected hot water on the control panel. after this it filled normally. then washed one cycle and would not refill on it’s own.

I can fill washer with the garden hose at this point and it will continue the rinse cycle

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 1

댓글 3개

Did it empty and fill than empty again befor

Darkened wolves 의 2019년 2월 17일

I am not sure but I will pay attention and add a note . Thanks for taking the time to post

David Major 의 2019년 2월 17일

Kenmore model 110

David Major 의 2019년 2월 21일

댓글 달기

게시일: 2019년 2월 18일

옵션

Hi @yoclem ,

You may have a problem with the cold water inlet solenoid in the washer.

Don't know your washer but on some when you select a hot water wash, on the wash (agitate) part of the cycle you get a hot water wash but not a hot water rinse which follows the wash, it is cold water. There may be only one wash type option (mostly wool wash -if you have it) that has a hot (or warm - hot and cold) rinse.

Check the user manual for your model to see what the rinse cycle temperatures are for each wash type option (regular, heavy, delicates etc) that you have.

If one of them has a hot (or warm) water rinse as part of the cycle try running that wash cycle with the water connected to the machine’s hot water inlet. If it fills for the rinse part of the cycle it points to a problem with the cold water solenoid.

What is the full model number of the washer?

해당 답변은 도움이 되었습니까?

예 아니요

점수 3

댓글 달기

Kenmore 400 Washer

My Washer fills then does wash cycle , drains but does not fill again.

답변 1개

귀하의 답변을 추가하세요